Feature

●Compatible PCs: DOS/V computers (models with DVI (24 pin) display connector)
●Supported Resolution: 1080p (1920 x 1080 dots) when using Category 7/6/5e (up to 100 meters)
●Compatible LAN Cable: Category 7/6/5e straight cable
●Extension Cable Length: 328.4 ft (100 m) (max)
●Power consumption: 11.4 W (max)
●Case Material: Steel
●Operating in environmental conditions: 11.2 - 104°F (5 - 40°C), humidity less than 80% (without condensation)
●Size: Transmitter: 5.5 x 4.4 x 1.3 inches (140 x 113 x 32 mm), Receiver: 4.7 x 2.9 x 1.3 inches (120 x 73 x 32


Description

HDMI extender that can extend the DVI signal up to 1080p (1920 x 1080 dots) resolution up to 100m.
The receiver side is PoE (Power over Ethernet) compatible, so there is no need to connect an AC adapter.
The transmitter side is also equipped with a DVI output, so you can check the video at your fingertips while still allowing you to output the DVI output.
The transmitter and receiver set allows you to extend between units using 1 Category 7/6/5e straight cable. 1
The infrared signal can also be transmitted, so you can control the remote control of your DVI device from the extension destination.
The contour structure takes into account the wall mounting function (wall mounted).
Ideal for installing display only in environments where DVI devices are difficult to install such as factories and construction sites, and when installing DVI devices in a good location away from the environment.

1. This product uses 1 straight cable of Category 7/6/5e. Please purchase separately.
Note: LAN cables should be used with a single wire specification of 24AWG/23AWG/23AWAWAWAWAWAWAWAWG/23AWAWAWAWAWAWG/23AWAW
Recommended Cable
Made by Sanwa Supply
KB-T7 Series (Category 7)
KB-T6TS Series (Category 6)
KB-T6L-CB100 (100m) / 300 (300m) (Category 6)
KB-T5T Series (Category 5e)
2. May not work due to the connected device or function.

Accessories: AC adapter (DC 48V/1.05A) x 1, power cable x 1, IE unit x 1, IR unit x 1, rubber feet x 8, instruction manual x 1.
Compatible output devices: DVI (24 pin) compatible display or projector (for single link mode). *This product only supports digital signals. Not compatible with analog signals. Does not support DVI dual link signals.
Interface (Transmitter): Input: DVI (24 pin) female x 1, 0.1 inch (3.5 mm) stereo mini jack x 1, Output: DVI (24 pin) female x 1, 3.5 mm stereo mini jack x 1, RJ-45 female x 1, IE and IR unit jack x 2.
Interface (receiver): Input: RJ-45 female x 1, Output: DVI (24 pin) female x 1, 0.1 inch (3.5 mm) stereo mini jack x 1, IE and IR unit jack x 2.
Bandwidth: Single link 165MHz/1.65Gbps per channel (4.95 Gbps all channel).