Feature

●Uses glass lenses that are double the magnification, scratch resistant, high transparency, and durable
●Covered clip for secure hold and scratch resistant
●Heavy square base for outstanding stability
●Estimated clip width for stable fixation: 0.2 - 5.7 inches (5 - 145 mm); Maximum opening width for clip tip: 0.5 inches (12 mm)
●※ If the frame comes into contact with a hot soldering iron tip, etc., it may get damaged. Please be careful not to hit it


Description

Support series for comfortable work. Recommended for electronic work support. Uses glass lenses with high transparency, durable, and scratch-resistant. Plastic frame prevents hand injuries caused by burrs. Square base size: 2.0 x 2.0 inches (50 x 50 mm); Weight: 16.2 oz (460 g) for stable soldering If the temperature gets hot, such as brazing, remove the clip cover and use. Heat shrink tube Φ3 for easy re-installation.



From the Manufacturer



ST-94/95 DescriptionST-94/95 Description

The lens edge is covered so it is gentle on your hands and increases safety.(Compare to our company) New joint mechanism for increased freedom! You can adjust the position and angle of the magnifier clip. Rubberized clip ensures a secure hold.(Using a 0.1 inch (3 mm) diameter heat shrink tube) Adopts a square base with good stability.Rubber bottom prevents slipping.Maximum clip opening width: approx. 0.5 inches (12 mm)

Precautions

It can be used for other than soldering assistance, but do not use for work where loads are subject to drilling.Use on a flat smooth desk or any other stable surface.Remove the tip cover if heat is heated to the tip of the clip.(Please check the ST-94 video for how to change the cover.)