Description:
The pillow block has a housing and two sealed insert self-alignment bearings to keep it in place.
The bearing housing is made of alloy and the bearing is made of chrome steel (GCr15) to provide low friction, vibration and noise.
Pillow block bearing has two bolt holes. Easy to replace.
The set screw secures the shaft to the inner wheel of the bearing to prevent slipping. We recommend the size of the hex wrench below.
Specifications:
Bearing Unit Number: KFL001
Bearing Number: K001
Housing Number: FL001
Housing Meteria: Alloy
Bearing Material: Chrome Steel (GCr15)
Bore Diameter: 0.5 inches (12 mm)
Bolt Hole Size: 0.3 inch (7 mm) (D)
Hole Center Distance: 1.9 inches (48 mm)
Recommended Mounting Bolt Size: M6
Recommended Wrench Size: 0.06 inch (1.5 mm)
Pack Quantity: 1