[outer diameter 165mm x inner diameter 20mm]
[outer diameter 190mm x inner diameter 20mm]
プロ機と同等の回転数·優れた作業性を実現
Remove the saw blade with the outer flange and hand pull the cover up to full.
To remove, push the shaft lock into the hex hole bolt that tightens the saw shaft using a hex key 5 to attach the saw blade to the hex hole bolt and turn it to the left.
Please do the opposite direction.Install the saw shaft with an inner flange, saw blade, outer flange, and hex hole bolts.The inner flange should be side by the device with an 19 stamp.Tighten the hex bolt tightly.When using a commercially available saw blade with a diameter of 0.7 inch (19 mm) diameter, please use the blade side with the 19 stamp on the inner flange.
When not in use, please store the hex key in the unit as shown in the picture.
Loosen the thumb screw on the cutout depth adjustment plate and adjust the base up to the desired depth.After adjustment, please tighten the knob tightly.