[set1]

[Slide hammer 18tabs]

Instructions
1. Surround the indentations with a clean wet cloth.
2. Mount the adhesive groove on the gun and the glue stick into the glue gun, pull the trigger to connect the power for 5 minutes.
3. Use the appropriate drawing gasket Large extension requires a large drawing gasket. (Note: The larger the drawing gasket, the larger the drawing force is.
4. Pull the trigger and apply the drawing gasket with extruded glue(4 holes in gasket have hot melt adhesive)
5.Gaskets in the fast location with hot melt adhesive in the center of the recess and gently press until the glue hardens (cool the glue for about 8 minutes. Cooling time should be less than 10 minutes and slightly shorter Winter);
6. Align the T-shaped repairer, push the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the recess
7. Please check the line board. If it still exists, knock it slightly with a flat hammer or pen.
8. Clean the repaired area with a clean wet cloth.