[2]
[10]
(Assembled Product) This is a set of 10 parts with a partition base for an impulse top mount, and a clamp type clip stand made of aluminum alloy (silver color).
It is a finished product, so it is ready to use.
Clamps over the top (tightens the base) so you can clip partitions and panels on top of a mini impulse or on a desktop impulse.
Suitable for pinching partition and panel thickness 3-6mm.
This is a finished product and has been tested for operation and function.
Easy to use.
Simply loosen the hex hole bolt that is inserted into the top clip with the included mounting tool (hex wrench), clip the partition and tighten the bolt.
The width of the mini impulse or tabletop impulse is about 0.6 - 2.0 inches (1.5 - 5 cm).
There are 4 screw holes on the top of the clip stand, so the top clip can be rotated 90 degrees.
However, you will need a Phillips screwdriver for this job, so please prepare it by yourself.
Rubber on both sides of the clamp to prevent scratches when tightened.
The clip is equipped with a silicone pad for partition protection.
There may be scratches on the surface due to impact during transportation, but it does not affect its functionality.
The clip may be reversed to the picture, but please change the direction according to your application (you will need a Phillips screwdriver).
Clip Portion: Approx. Height 2.5 inches (63 mm) x Width 1.2 inches (30 mm), Bottom 1.8 inches (45 mm) x Thickness 1.3 inches (33 mm) (when panel is not installed).
Clip stand (approximate): Height 2.0 inches (5 cm) x Width 2.0 inches (5 cm) x Width 2.6 inches (6.5 cm) (clamp rod included): 3.5 - 4.9 inches
Net Weight: Approx. 11.3 oz (330
Material: Aluminum alloy for durable and long lasting use.