Feature

●For staining plastic (plastic models, mini 4WD etc.)
●Compatible Materials: Polycarbonate (PC), Acrylic, ABS, Pet (PET), Polyester (PES), Polyurethane (PU). Please check the material carefully when using. Even the material that can be dyed will not stain when coated. Example: Polycarbonate helmet visor (hard coated)
●Finish using the material and permeability
●✅ Higher color, higher saturation, and permeability compared to paint, so you can use the material to finish it
●The finished product has a low odor and is recommended for accessories, and indoor use

[emerald green]

[grey (grey marl)]

[raspberry red]

Description

Plastic staining

Compatible Materials:

Polycarbonate (PC), Acrylic, ABS, Pet (PET), Polyester (PES), Polyurethane (PU), etc.

Can be finished using materials and transparency. Compared to paint, it has higher colors, higher saturation, and permeability, allowing you to create a finish using the material.The finished product has a low odor (*) accessory and is recommended for indoor use.This product is flammable and does not contain toxic drags, so you can use it with confidence.Please do not attempt to avoid dangerous acts such as igniting or eating, etc.

The color of the actual product may differ slightly from the product depending on your monitor settings, lighting, etc.The color swatch is an image and may differ from the color samples depending on the material, dye temperature and time.

How to Use:


Dyes resin molded (acrylic in the picture) Pink is used.	STEP1 Clean resin molded items with mild detergent.	STEP2 Shake the product more than 30 times. Place the dye solution in the container and dilute 1:20 with cold or hot water.


STEP3 Insert resin into the dyed liquid, stir it to prevent uneven dyes, and boil for about 3 to 9 minutes at an appropriate temperature (70 to 90 degrees Celsius) and dye to your desired color.Please be careful with boiling water.	STEP4 Check the dyeing status at any time while mixing well.	STEP5 Remove the stained resin and place it in warm water with a mild detergent, then dry it and youre done.

How to Use:

When dying, boiling while touching the bottom of the container may cause unevenness.We are not responsible for the nature of our products, if there is any inconvenience in the workmanship.The temperature of the resin may vary depending on different conditions.Advance dyeing test is recommended.Low temp and shorter time can be dyed thinly, higher temperature and longer time can be dyed darker.The color will fade slightly from sunlight and UV rays.The color may fade with alcohol solvents.

Safety Measures:

Please ensure sufficient ventilation when working.Please use the mask on the wind to prevent volatile components and especially steam when heating.Please be careful not to swallow or stick to the skin or get into your eyes.Please close the lid tightly after use and store in a cool, dark place where children cannot reach.Please use it all in a few days after opening.Storage may reduce the dye power.Do not use stained products on food or biological containers.

First Aid

If swallowed by mistake, rinse your mouth and consult a doctor immediately.If it gets in your eyes, immediately wash the eye behind the eyelids with clean running water for more than 15 minutes and consult a doctor.If inhaled, please rest in the fresh air and see a doctor.If it gets on your skin, please wash it thoroughly with a large amount of clean running water and soap or skin detergent.Seek a doctor if you have changes in appearance or pain in your body.If you are not aware of the victim or other abnormalities, please immediately consult a doctor.

Disposal:

Contents and containers must be disposed according to your local government regulations.Run the solution 50 times more water and discard it in the sewer slowly

Plastic staining

How to Use:

STEP1

STEP2

STEP3

STEP4

STEP5