|
|
|
|
---|---|---|---|
Tenkoku Chisel |
Water-resistant paper for stone |
mud |
Tenkoku Vice |
|
|
|
|
---|---|---|---|
Hold pencilCarry pencil The edge of the blade is dangerous, so be careful not to lose the cap. |
Push the blade into the stamp surfacePlace the blade on the stamp and add the thumb of the opposite hand. |
Press with thumbSlowly press the back of the blade with the attached thumb to inscribe the stoneYou can use a sword with less slippage of the blade. |
Do not put the stamp knife too lying down.If you put the stamp knife too lying down, the blade edge will dig into and you will not be able to achieve a smooth lucky knife. |
|
|
|
|
---|---|---|---|
1. Polish the stamp surfaceUse water resistant paper to polish markings and eliminate seams. |
② Draw and transfer the design.After drawing the design on the tracing paper, flip it over and place the carbon paper between the markings and rub it onto the paper. |
3. Carve with an stamp knife.Carve with an stamp knife.When you finish carving, remove the stone powder cleanly and press it on a test.If there is any excess part, fix it with a stamp knife. |
Done!Use them for letters, artwork, and more! |
|
|
|
|
---|---|---|---|
Write on with pencil, transfer is now easy! |
1. Apply the stamp surface with POSCAApply POSKA orange on the stamp and let it dry well. |
2. Transfer the drawing on the tempeDraw a design on the tempe, flip it over the dry markings and rub it on. |
3. Draw with pencils.If it does not show well, you can easily fix it with a pencil. |