Feature

●♣【11 Piece Network Cable Tool Group】: You can make the network cable by yourself. After making the cable, you will diagnose the tester for any problems. Convenient set for beginners
●♣【COMPATIBLE DESIGN】: LAN crimping tool is compatible with 4 pole, 6 pole, 8 pole modular plugs, allowing you to apply firm force. LAN cable tester, the blade for cutting cable film is sharp, cut neatly
●Applications: LAN tool set is very convenient for building wired networks in homes, offices, laboratories, and other factories
●Set Contents: Crimping tool x 1, Punch tool x 1, Stripping tool x 3, Screwdriver x 2, LAN cable tester (for RJ45, RJ11) x 1, Connector storage box x 1, Bag x 1, Battery not included
●Features: (1) The blade that cuts cable film is very sharp and cleanly cuts. (2) You can check cable connection, disconnection, mis-wiring and grounding. 3. DIY network cable


Description

Introducing this set:

This device is designed to identify and trace wires and cables without damaging the insulation properties.
Designed for scanning and test phone lines, alarm cables, computer cables, intercom lines, speaker wires, and thermostat wiring.
Check the working condition of each wire and test the corresponding double-stranded cable 1,2,3,4,5,6,7,8 and ground
It can judge the wrong connection, conduction, short circuit, open circuit, even the cable behind the wall.
NS-468 cable tester for (RJ11, RJ45) has incorrect connection requirements.
1. When one cable is open, such as cable NO.3, the master and remote tester two NO.3 lights will not turn on.
2. If some cables are not connected, there are no more than 2 cables connected and the lamp is not lit, some lights will not light up.
If the two ends of the cable are cluttered like NO.2 and NO.4, then the light display will be as follows:

Master Tester: 1-2-3-4-5-6-7-8-G
Remote Tester: 1-4-3-2-5-6-7-8-G
4. If the two cables are short circuited, the light will not light up by the master tester of two cables, but the remote tester for two cables has a little light.
If 3 or more cables (including 3) are short-circuited, the 3 cable lights will not turn on all of the 3 cable lights in both the master tester and remote tester.
Power switch for power saving, "OFF" for power off, "ON" for manual mode, and "S" for slow automatic mode
Operates with one 9V battery (not included).

Network Punch Down Impact Tool:
Blade is inserted precisely and economically trim wires
Durable punch down tool allows for easy network installation
Specially designed wire hooks remove terminated conductors.
The blade allows you to easily remove the block from the back-mount frame.
This is a punch down tool for inserting wires into sockets, patch panels, or outlets.
Specially designed tools for terminating and trimming wires with a low impact punch bring new ease and speed to all your equipment.

Package:
1 x NS-468 Master Cable Tester
1 x NS-468 Remote Cable Tester
2 x Strip Knives
1 x Strip Pliers Knife
1 x Punch Down Impact Tool
1 x Small card knife
1 x Phillips screwdriver.
1 x Slotted Screwdriver
1 x LAN connector set of 10