Parameters
Print Type: Direct Thermal Line Printing
Dot Density: 384 Dots / Line (default)
Resolution: 203DPI x 203DPI
Paper feed method: One-way friction feed
Printing Width: 8 dots/mm, 48mm
Number of Columns
Character spacing (default): 30 dots (3.75mm)
Note: Use emulation commands to adjust the spacing of the letters. The increments are 0.125mm.
Printing speed: Up to 90mm/s speed depends on the data / command transmission rate, input voltage, and printing density.
Paper feed speed: about 100mm/s
Paper feed: 0.125mm (one step spacing of feed motor)
Printing columns: up to 32 columns (12x24 font), up to 16 columns (24x24 Chinese)
Character Set: Data Buffer
Receiving buffer: 4K bytes
Auto cutter: full, partial
Paper Near End Detector: The diameter of the roll paper detection range is 0.6 - 1.7 inches (16 - 42 mm) (calculated at the center of the roll).
Interface: Serial: HX connector, RS-232C compatibility, RTS / CTS handshake, Asynchronous communication 115200 (default), 9600/19200/38400/57600 options
Paper: High quality thermal paper, smooth surface, 65-100 µm thick. : Emulation Command
Compatible with Epson ESC / POS
Paper Width: 57.5 +/- 0.5mm
Roll Paper Outer Diameter: Max 150mm
Roll paper inner diameter: at 65µm to 100µm thickness, minimum inner diameter of 25.5 +/- 0.5mm.
Paper Winding Direction: It must be printed on the outside of the paper.
Pint side: Outside the paper
Voltage: DC: 12V