Feature

●Imported high quality motor steel plate, bearing made of German technology, low self-inductance, good responsiveness
●Products can be connected directly to the load and run at a low speed close to the locked rotor, without slowing down the gear
●This product produces a high torsion-to-inertia ratio on a load shaft, eliminating system errors caused by using deceleration gears
●The inner rotor adopts German technology, the surface is coated with imported rotor adhesive to prevent carbon steel oxidation and burr after grinding, so the motor noise increases
●The front cover and rear cover are fully connected, the body is black electrophoretic, high-end atmosphere, and body size are standard


Description

Specifications:

Item Type: Electric Motor

Material: Carbon steel
Purpose: Industrial motor control, transmission, transmission occasion
Step angle: 1.8°
Voltage:Determine by the equipped driver, no fixed voltage
Current: 1.5A
Holding twist: 0.28N.m
Resistance: 2.4Ω
Inductance: 2.8 mH / phase
Length: Approx. 34mm/1.3"
Number of Outlets: 4
Shaft Type: Milling Machine Single Flat Table
Step angle accuracy: ±5% (full step)
Resistance accuracy: ±10% (20℃)
Inductance accuracy: ±20% (1KHZ)
Temperature rise up to 176°F (80°C) (rated current, 2-way electricity)
Ambient Temperature: -4°F to 122°F (-20°C to 50°C).
Insulation Resistance: 100 MΩ Min, 500 VDC
Withstands 500 VAC voltage for 1 minute
Radial Clearance: Maximum 0.0008 inch (0.02 mm) (15.7 oz (450 g) load).
Axial Gap : Maximum 0.08 mm (15.7 oz (450 g) load)
Maximum radial load: 28N (0.8 inch (20 mm) from flange surface)
Maximum Axial Load: 10N

Package List:

1 x Electric Motor