1. First, measure the length and width of the car glass.Cut to the size of the car glass you measure, add 20mm to cut.Make sure to put it on the back when you put it on the mark.
2. Paste the cellophane tape to the corners of the release film and glass film, then peel off the glass film release film.Spray plenty of water on the adhesive side of the film.
3. Spray the car glass with a large amount of water.Apply to glass surface while stretching parallel to car glass.
4. Push out the air and water between the glass face and the film from the center and outward with a plastic spatula, etc. (even a ruler)We recommend cutting 0.08 inch (2 mm) smaller than the rubber gasket inside the sash to prevent peeling.