Confirmation before purchase
Please make sure to install it in a location that does not protrude from the exterior.The overall width of the vehicle will change if it protrudes from the outside of the vehicle, so changes in the structure and the vehicle verification are required.
Before you buy this item, please make sure to check the following information.
Preparation: tape and other (for masking), thread
1. Mark the exterior of the front fender with tape.
2. Mark the outside of the quarter (rear fender) with tape.
3. Connect the front fender marking position and quarter marking position with string.
4. When the width between the body and the thread is 1.4 inches (36 mm) in the position where the blind side camera is installed, it can be equipped with a fixed camera angle (BSC261-S), and a camera angle adjustment type (BSC262-M).If the width between the body and the thread is 1.3 inches (33 mm), it can be attached to the camera angle fixed (BSC261-S).
In addition to the dimensions of the blind side camera cover, the thickness of the double-sided tape, paint and the error of urethane shrinkage, etc.