[red anodized]

[blue anodized]

[Chrome Plated]

[purple anatomite]

商品紹介

This type is hard to be affected by the conditions. Comes with a hood, so it is effective against dirt and dust, as well as rain. Increases intake efficiency and increases power.
Dimensions are measured vertically and are from the top of the filter to the bottom of the rubber pipe. Recommended air filter for normal carburetors.

Please pay attention to the mounting angle. Installing the cover upside down may cause water to accumulate inside the cover and interfere with the intake.
Carburetor setting is required for installation. Carburetor setting is required as the intake efficiency changes
When driving in rainy weather, moisture may enter the filter and the carburetor setting may change.
If the filter diameter is a few millimeters smaller than the carburetor caliber of your car, it will be slightly tighter when tightened, but you can put it on by pushing it in.
If you wear the long rear shock, the dimmer may interfere with the body.

■About emissions regulation model from 2000 model:
Since this model has a rare and thin exhaust regulation, there may be no settings on it, so we cannot recommend installing a power filter etc.

■About F1 car:
For F1 vehicles, please do not install a power filter or air funnel, as the fuel adjustment will be lost.
However, if you install the fuel adjustment device (injection controller and Kitaka-made I-MAP) and you can set it up.

ご注意（免責）＞必ずお読みください

This is an example of the compatible model. Please make sure you do not mind before placing your order. We cannot accept returns or exchanges due to customer circumstances