Feature

●Stylish adjusters for 2x4 wood boards.
●A LABRICO series DIY product for renters.
●Easy for anyone to install.
●Supports 2x4s without scratching your ceiling or floor.
●No tools required.Simply turn the jack to fix your 2x4 firmly in place.

[whites 2 x 4 adjusters Single Item]




[blk For 3 x depth expansion parts Single Item]




[whites For 3 x depth expansion parts Single Item]




[blk 1 x 4 adjuster Single Item]




[blk Joint Single Item]




[whites 2 x 4 adjusters DIY Storage Parts + DIY Storage Parts DXO-52]




[blk 1 x 4 Anti-Scratch   &  Anti-Slip Pads Single Item]




[blk 2 x 4 adjusters Single Item]




[whites 1 x 4 adjuster Single Item]




[whites For 2 x depth expansion parts Single Item]




[blk Shelf Support Single Item]




[blk Anti-Scratch   &  Anti-Slip Pad 2 x 4 Single Item]




[whites Joint Single Item]




[blk For 2 x depth expansion parts Single Item]




[whites Shelf Support Single Item]





Description

LABRICO(ラブリコ) アイアンシリーズ
「木材×アイアン」の重厚かつ品の良さが空間を引き立て、様々な場所やスタイルにマッチします。

【商品寸法】
幅8.6×奥行4.3×高さ[上キャップ]10-12.2 [下キャップ]0.5cm

【使用荷重】
·柱に対し片側に荷重がかかる場合は20kgまでとしてください。倒れる恐れがあります。(棚板を使用する場合は棚板の重さも含みます)
·使用荷重は実験値です。設置場所や、使用木材によって条件が変わる為、保証するものではありません。

【取り付け時の注意事項】
·この商品は屋内専用です。
·市販の2×4材(38×89mm)に装着し、床と天井に突っ張ることを目的とした商品です。
·天井の高さから75mm短い2×4材をご用意ください。
·使用サイズは縦方向で2750mmまでとしてください。
·使用する2×4材に反りや曲がりがあると正常に装着や設置ができない場合があります。
·下地のしっかりした場所に設置してください。下地の弱い所に設置すると転倒の原因となったり、天井を破損したりする恐れがあります。
·傾斜した天井、床面には設置しないでください。また床と垂直に設置してください。
·この商品は一般家庭の天井の高さを想定した商品です。
·縦突っ張り専用です。横向きには使用しないでください。
·高温となる所、屋外や直射日光の当たる所、浴室や湿度の高い所、水が掛かる所には使用しないでください。
·転倒することもありますので、自転車、テレビ、貴重品はかけないでください。

【使用上の注意】
·よじ登ったり、ぶら下がったりしないでください。
·危険物、貴重品、破損の恐れのある物は載せないでください。
·消臭剤、芳香剤、化粧品、整髪料、酸性洗剤、アルカリ性洗剤、油脂、有機溶剤(ベンジン、シンナー等)の付着は変質劣化の原因になります。直ちに取り除いてください。
·破損やひび割れなどの異常が発生した場合は、直ちに使用をおやめください。
·天災などの不可抗力、経年劣化、改造、誤った使用方法による故障、破損、事故などに対する補償等はいたしかねます。
·日本国外に持ち出された商品は、補償の対象外となります。



From the Manufacturer



2 x 4 adjuster iron 1 x 4 adjuster iron Shelf Iron Joint Iron
2 x 4 adjuster iron 1 x 4 adjuster iron Shelf Iron Joint Iron
Size: Width 3.4 inches (8.6 cm), Depth 1.7 inches (4.3 cm), Height 4.0 - 4.8 inches (10.0 - 12.2 cm) (top cap) 0.2 inches (0.5 cm) (lower 3.4 inches (8.6 cm), Depth 0.9 inches (2.3 cm), Height 4.0 - 4.8 inches (10.0 - 12.2 cm) (top cap) 0.2 inches (0.5 cm) (lower cap 3.4 inches (8.6 cm), Depth 1.4 inches (3.6 cm), Height 1.4 inches (3. 3.4 inches (8.6 cm), Depth 0.1 inches (0.3 cm), Height 2.8
Material: Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Pad: Synthetic rubber; Screw: Iron, plating Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Pad: Synthetic rubber; Screw: Iron, plating Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Screws: Iron, plating Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Screws: Iron, plating
Color variations white/black white/black white/black white/black
PACKAGES Adjuster, instruction manual (English language not guaranteed), screws (4 pieces), pads. Adjuster, instruction manual (English language not guaranteed), screws (4 pieces), pads. Shelf supports (2), screws (8), instruction manual (English language not guaranteed) Joint (2 pieces), screws (8 pieces)
Working load (working load is laboratory value.The conditions may vary depending on the location of the installation and the wood used. Up to 44.1 lbs (20 kg) when load is applied to one side Up to 22.0 lbs (10 kg) when load on one side against the pillar. 66.1 lbs (30 kg) per shelf (shelf length up to 47.2 inches (120 cm)) Up to 22.0 lbs (10 kg) when load on one side against the pillar.
Telescopic Rod S Irons Telescopic Rod M Iron telescopic rod large iron
Size: Width 50-70cm, Depth 3cm, Height 3cm Width: 27.6 - 43.3 inches (70 - 110 cm), Depth: 1.2 inches ( Width 110-190cm, Depth 3cm, Height 3cm
Material: Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Screws: Iron, Plating, Resin Parts: ASA resin Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Screws: Iron, Plating, Resin Parts: ASA resin Body: Iron, cationic electrodeposition coating + epoxy resin powder coating; Screws: Iron, Plating, Resin Parts: ASA resin
Color variations white/black white/black white/black
PACKAGES Rod, socket (1 large, 1 small), screws (4 pieces), instruction manual (English language not guaranteed) Rod, socket (1 large, 1 small), screws (4 pieces), instruction manual (English language not guaranteed) Rod, socket (1 large, 1 small), screws (4 pieces), instruction manual (English language not guaranteed)
Load Capacity: 88.2 - 44.1 lbs (4 88.2 - 33.1 lbs (4 88.2 - 22.0 lbs (4