Feature

●This film is mainly used for car film. This is a film that is applied from the inside of the glass chamber
●Commercial wind film from a domestic manufacturer, of course, color loss (fading) is almost unnecessary. The color of the screen display may differ slightly from the actual product
●The film thickness is about 25 microns and feels much more sturdy than the ones on the market. This product is also compatible with heat molding rear glass
●Compared to other film on the market, it has a hard coat finish, so it is less likely to get scratches when opening and closing the window and making it less likely to get scratched even when draining water
●Width: Approx. 42.1 inches (107 cm); Quantity: 1 is sold in 3.3 ft (1 For example, a quantity of 3 will be a connected film of 9.8 ft (3 m). If you purchase more than 1m, you can add to cart → proceed to checkout → change the quantity to purchase the desired length


Description

Product description

Visible Light Transmittance: 88% UV Transmittance: 1% Shielding Coefficient: 0.85 Visible Light Transmittance means how much brightness in the sun can enter the room. The higher the number, the lighter the film color. UV transmittance is (ultraviolet = UV)... The smaller the UV rays (UV) on the areas that sunshine the skin and interior materials in the sun, the better the UV effect. The shielding coefficient is a 0.1 inch (3 mm) float glass that represents the amount of incoming heat in the sun. The lower the value, the better the shielding effect and reducing air conditioning. The data is the actual measurement of the film attached to the 3mm float glass and is not guaranteed. ★Only stick to smooth glass surfaces. (Cannot be applied on uneven glass surfaces such as pick-glass or stained glass)

ご注意（免責）＞必ずお読みください

★Window film cannot be applied other than glass. ★ If high temperature is expected, the film may change color or poor performance depending on the environment where heat or moisture is prone to accumulate and surrounding environment. ★ When installing on meshed glass or heat absorbing glass, there may be cases of heat breakage, so please perform thermal cracking calculations beforehand. ★ There may be cases where the film surface may appear cloudy or water foamy objects after installation, but this is a phenomenon that the moisture is dry during the installation process. ★Please note that the film is applied on interior surfaces (applied on interior surfaces) and products that are used to stick on the inside. ★Only stick to flat glass surface