[50cm*300cm]

How to Use: 1. Measure the length and width of the car glass. 2. Cut the size of the car glass you measured and add 20mm to cut. Make sure to put it on the back when you put it on the mark. 3. Paste the cellophane tape to the corners of the release film and glass film, then peel off the glass film release film. 4. Slowly peel off the release film and spray on the adhesive side of the film with plenty of spray. 5. Spray the car glass with a large amount of water. 6. Stick it to the glass surface while stretching it parallel to the car glass. 7. Spray again on the film you have pasted and spray. 8. Apply the release film to the film body. 9. Push out air and water between the glass face and the film outward from the center and outward with a plastic spatula (also a ruler). 10.Peel off the release film 11. Push out air and water inside the glass film to the fullest, then cut it off and cut it with a cutter. We recommend cutting 0.08 inch (2 mm) smaller than the rubber gasket inside the sash to prevent peeling. 12. Finally, you can wipe the moisture thoroughly and it is done. Note: 1. Please use a mild detergent to remove dust, dust, dirt, etc. on the glass surface and make it shiny. In some cases where dirt on the frame will become trapped and dirt will get in. Please clean the frame thoroughly. 2. The trick is to apply it to the glass or the adhesive surface of the film, so that it will drip off with plenty of water. 3. When applying large size film, it is recommended that you use 2 people to avoid creases. 4. In the experiment, you can put a mild detergent into water, mix well and paste it with soapy water to make it more clean.