Parameter:
Size: 0.7 x 0.6 inches (18.5 x 16 mm)
Input Voltage: 3-10V
Single H bridge output current: 1.5A can drive two deceleration motors.
Built-in protection latches for overheating undervoltage overcurrent protection and short circuit protection. Low power consumption and sleep mode
Purpose: drive motor up to 1.5A and 4-wire stepper motor
Instructions:
ULT low level is sleep mode (spot welding behind short modules required for cutting J2)
It is IN1, IN2 and supports OUT1, 0UT2 controls, and is one H bridge.
IN3, IN4 and second H bridge that supports OUT3, 0UT4 control.
To protect EEP output, it is not default.
VCC for 10V input voltage 3
GND is grounded
Package included:
30 x Motor Driver Board