Feature

●DC motor driver input voltage range is 6.5V DC-27V, input DC 12V or 24V, each port rated output current is 7A, total output power is 160W.
●STRONG DRIVE:The motor controller board can drive two DC motors at the same time and adopts dual H bridge.
●FORWARD and REVSERSELY ROTATE: IN1, IN2/IN3, IN4 port forward control or reverse motor rotation.
●PWM Speed Control: Signal Enable Terminal (ENA) Input PWM can adjust the speed, PWM frequency range 0-10KHZ.
●Low Voltage Protection: The motor driver module is under voltage protection to prevent the module from damage instantaneously large current.


Description

Parameter:

1. Power supply voltage 6.5V, 27V, power supply can not be reversed or over 27V or burned module, it is recommended to connect to a series 15A fuse for the power input.

2. Dual motor interface, each rated output current 7A, peak current 50A, motor interface can not be short-circuit, it is recommended to connect to series 15A fuse.

3. Enable the signal and control voltage of forward and reverse control signals 3-6.5V.

4. Enable the signal terminal (ENA) input PWM which can adjust the speed and PWM frequency range 0-10KHZ, 10 US width PWM minimum pulse.

5. Product Dimensions: 55x55x16mm

6. Installation hole diameter: 0.1 inch (3 mm) backside to prevent short circuits when installing, you can add insulation pads or rows of copper to enhance circuit board.

Matching parameters:

Long-time rated voltage of 24V, rated power below 115W, and motor with motor to identify work full of 7A rated current.

Note:

27V - 1. The drive power cannot be reversed, connect to the power interface 15A fuse, voltage should be between 6.5 is recommended. If the voltage is exceeded, it may burn the drive module.

2. When it starts the power supply rated output current may cause a pause of the drive module under it, it is recommended that the power voltage cannot reach the required input voltage of the motor, so it is better to double the voltage protection.

3. The motor interface can not be short-circuited or can burn drive modules, it is recommended to connect to the motor interface with series 10A fuse.

Package included:

1 x DC motor driver board
If you have any questions, please feel free to contact us. We will do our best to provide you with the best services. We will send you the item as soon as possible. The logistics speed is faster than the Amazon website.