[One Size black]

Stepper Motor Noise Reduction: Easy to hear stepper sound reduction.
Description:

RAMPS 1.6 is activated based on optimized ramp and 1.4 & 1.5 ramp.
The Calcogeno Fulvalon skeleton is almost the same as the ramp 1.5, and the difference has a good heat sink on the MOS tube, so that the ramp 1.6 is not easy to burn. It has a new 2-pin connector that is easier and more convenient to connect. It has excellent heat dissipation.

In addition, when the power of a ramp 1.6 is larger than a ramp 1.5, the maximum power consumption is 270 W or maximum, and the ramp can be up to 200 W or 200 W samler.

Features:

5 Applies to Pololu Stepper Drive Board
Easily replace Pololu plate pin socket design or remove for future design
I2C and SPI pins are prepared for future expansion
Servo connectors are used to stop limiting and connect motor and luminous diodes. These connectors are gold-plated and very compact with a rated current of 3A.
10. LED has a heater output, choose two motors that connect to optical Z Prusa Mendel

Specifications:

Size: 4.0 x 2.4 inches (101.5 x 60.5 mm)
Support Motor Driver: Support A4988 DRV8825 and other motor drivers (supports 5 motor drivers at the same time)
Input Voltage: 12V
Power: 200 W
Patch MOS Tube: B55NF06

Note:
You do not need to insert the short circuit cap under the driver plug in 1.If, plug into the TMC2100 driver.
2. Whatever tmc2130 is the quietest, and it will raise 1.5 or 1.6 lamps compared to all drivers.

Package includes:

1 x Ramp 1.6 Control Board
1 x Heat sink
Some jumper caps

Service:If you have any question about the product please buy our products.If, please consult our customer service and come to wish you a happy shopping!
It has a USB interface that is easy to connect and operate.