Feature

●Network surge protector suppressor protects a single line of data, including computer network signals, communications equipment, etc. Insert the network cable surge protector into the data cable and connect it to the ground to prevent lightning surge. This means you wont waste your money even if you dont damage your device.
●Multi-level protection circuit, high-speed protection accessories, low capacity design, fast response, low output residual voltage, and good transmission performance.
●Standard RJ45 shielding interface of Ethernet network surge protector is suitable for overvoltage protection of ETHERNET 10/100M BASET network devices (SWTICH, HUB, ROUTER, etc). Suppresses high voltage pulses on the line and protects backend equipment from lightning and industrial surges
●There is no "In" or "Out" cable side for this device. Both sides are the same RJ-45 interface. Whether the protected device is behind a specific side or not, it will work properly when you connect the correct cable.
●Network surge protectors are connected in a series before input of protected devices. Network Surge Protector input is connected to an external signal cable. Network Surge Protector output is connected to the signal input of the protected device. Connect the green ground wire to the ground.


Description

Port connection mode: RJ45 port
Nominal Voltage: 5V
Maximum Continuous Operating Voltage UC: 8V
Nominal discharge current IN: 5KA
Protection level UP: ≤45V
Data transmission speed VS:100Mbps
Usable temperature range: -40°C to 154°F (-40°C to 70°C).
Rectangle size: 65 x 25 x 25 mm
Ground Cable Length: 6.3 inches (160 mm)
Grounding: Direct ground with connection wire
Network surge protectors have a lower voltage to protect against damage caused by inductive thundering or other surge or overvoltage to protected devices.