This product is intended to adjust and measure the air pressure inside the tire.
Batteries cannot be replaced.
■Measurement range: 10kPa - 1100kPa
■Recommended Operating Temperature: -4°F to 140°F (-25°C to 60°C)
■Country of Origin: France
■Product Number: SCH000039902
Precision:
Less than 400 kPa: ±8 kPa
400-1000kPa: ±16kPa
1000 kPa or higher: ±25 kPa
Caution for Safe Work
Before inflating the air, please check that the tire and wheel are not abnormal.
Please use air that has been adjusted properly with a pressure regulator valve according to the tire size.
Please inflate with air using a safety enclosure.
When inflating the air, measure the tire pressure as appropriately as possible, and be careful not to overfill the air.
Precautions for Use:
Remove the protective film from the display surface.
Please use clean air or nitrogen filtered by the filter.
To prevent oil and water from entering the air, please drain and clean the compressor or or the air pipe.
For automatic calibration, please use the supplied air pressure within a range of 300 kPa to 1300 kPa.
Please do not use this product if anything other than air is infused in the tire (liquid, puncture prevention agents, etc.)
Never fix the injection lever while inflating.
Please do not disassemble the product.
Please do not use gasoline, thinner, etc. to clean it. It may cause deformation and clouding.
Always ensure no air leaks from the hose, coupler or joints.
Dropping, throwing, or rough handling may cause damage and low precision.
Please remove the valve core and do not inflate it.
How to use the gauge:
1: Connect the coupler side to the hose side chuck to automatically calibrate it in 3 to 5 seconds (if pressure is detected), so please inflate the air after the automatic calibration is completed.
2: Connect the chuck on the end of the hose to the tubeless valve. Please connect firmly to prevent air leakage.
3: Hold the lever when filling air.
5: Press the button to decrease the air.
6: Quickly display tire pressure when lever or button is released.
After adjusting and measuring the air pressure, please check that there is no air leakage from the tubeless valve.
For Use:
Even if there is no air leakage, the number displayed on the display board may be changed.
It takes several seconds for the measurement to be stable depending on the state of pressure or decompression.
Please adjust the internal tire pressure according to the instructions provided by the car manufacturer and tire manufacturer.
Even under normal conditions, there are factors that can change the internal tire pressure such as temperature, altitude, weather or natural reduction (regular air pressure check is recommended).
Display Board Display:
When the air check is connected to the tire valve and pressure is detected, the display plate will automatically be bright.
When you remove the air check from the tire valve, the display board automatically darkens
After you display the measurement numerals, it will automatically darken the display board.
When pressurized and decompression work, the display board will be bright again.