Honforged hand finished with fine craftsmanship.

[Use]
Processing holes in wood, etc.

Features:
The most basic chisel that can be used for a wide range of applications, including assembly parts.
The back is processed (back of 3) into 3 fine sections.
The remaining side parts between the skinning and skinning process act as a regulation role and allow the chisel to penetrate straight into the wood.

[Precautions]
For woodworking.
Do not use for anything other than the intended purpose.
This is a blade, so please handle with caution.
Please do not use if there are cracks on the wooden handle or the blade.
Because it is a sharp knife, it is dangerous, so please be sure to handle it with the handle.

From the Manufacturer

Senkichi Gold Extract Only, Back Side Coating

The craftsmanship of this hammered hand made finish.

For processing holes in wood, etc.

A basic chisel that can be used for a wide range of uses, including assembly parts.

Features of textured back

Blade width: 0.1 - 0.4 inches (3 - 9 mm) (backing processing: 1 piece)

The back surface of the blade reduces resistance and when sharpened with a blade that improves the penetration of the wood, it is possible to sharpen the blade more efficiently.

Blade width: 0.5 - 0.9 inches (12 - 24 mm) (back processing: 2 pieces)

Blade width: 1.2 - 1.7 inches (30 - 42 mm) (back processing: 3 pieces)

The back of the 2 and 3 sides are made with thin and 3 sections that are divided into 2 or 3 sections, so that the surface remains between the skimming and skinning processing, allowing the chisel to be plugged straight into the wood.

How to use only 1:

Hold under the wig of the handle with your left hand and let it stand vertically while looking at the top for a basic.

Use the chisel with the blade width that matches the width of the hole.

How to use only 2

1. Smice 2. Place the chisel at right angle with the back of the blade front on the inside of the surrounding 0.08 inch (2 mm) and tap the handle into the digging line.The chisel firmly grips the wig.	3. Fold the chisel toward the cut that was made 60 degrees and dig it in.	4. Repeat the action until the smitting is 0.1 - 0.04 inch (3 - 1 mm) before the smitting.	5. Finally, digging it out until it is full of smitting, and drill a hole.

	1 Panel Back	2 panels back	3-panel back
	Add to Cart	Add to Cart	Add to Cart
Customer Reviews	3.9 out of 5 stars 82	3.9 out of 5 stars 82	3.9 out of 5 stars 82
Price	¥4,100¥4,100	¥5,382¥5,382	¥6,294¥6,294
Product	Pass Only, 1 Panel Back	Pass Only, 2 Panels.	Pass Only, 3 Panels.
Available in sizes	3/6/9mm	12/15/18/21/24mm	30/36/42mm