Product Description

This is the only addition to the original hand-forged finish that takes on the craftsmanship of the product.

[Use]
Processing holes in wood, etc.

Features:
The most basic chisel that can be used for a wide range of applications, including assembly parts.

[Precautions]
For woodworking. Do not use for anything other than the intended purpose.
This is a blade, so please handle with caution. Do not use if there are cracks in the wood handle or blade.
Because it is a sharp knife, it is dangerous, so please be sure to handle it with the handle.

Amazon.com Review

●組手部分の加工に

From the Manufacturer

Senkichi Silver Award for Adding Only, For Woodworking Red Oak Pattern

Processing holes in wood, etc.

The craftsmanship of this hammered hand made finish.

A basic chisel that can be used for a wide range of uses, including assembly parts.

Specifications:

• Blade Width: 0.1, 0.4, 0.4, 0.5, 0.7, 0.8, 0.8, 1.2, 1.2, 1.4, 1.2, 1.2, 1.2, 1.2, 1.5, 1.6 inches (3,
• Steel
• Steel: Hitachi Yasuji Steel Yellow Paper
• Pattern: Red Oak

How to use only 1:

Hold under the wig of the handle with your left hand and let it stand vertically while looking at the top for a basic.

Use the chisel with the blade width that matches the width of the hole.

How to use only 2

1. Smice 2. Place the chisel at right angle with the back of the blade front on the inside of the surrounding 0.08 inch (2 mm) and tap the handle into the digging line.The chisel firmly grips the wig.	3. Fold the chisel toward the cut that was made 60 degrees and dig it in.	4. Repeat the action until the smitting is 0.1 - 0.04 inch (3 - 1 mm) before the smitting.	5. Finally, digging it out until it is full of smitting, and drill a hole.