For unit bath only.
Embedded into the bathroom ceiling with additional heating, drying clothes, drying the bathroom, ventilation, cooling air and 24 hour ventilation functions.
Integrated
Space-saving design/high power/multi-functional type.
Auto louver lets you focus hot air on the floor for air flow.
Easy to reach to the floor and keep your feet warm
Circulation blower and ventilation improves the drying efficiency of your bathroom.
Emits "Nanoe" into the bathroom.
Prevents floating mildew
Equipped with eco-friendly navigation system for a great dry experience.
Built-in temperature sensor and humidity sensor.
200 V high output KW compatible with UB1.5 tsubo)
Separate signal line for wired remote control from main unit
The unit can be installed and separated for electrical work.
Can be installed even with a wire tip.
Comes with a function to notify you of court inspection.
Includes filter check notification function.
Please read the construction instructions carefully before installing the product.
In bathrooms with poor sealing properties or insulation, the bath ventilation and dryer may not work well.
In particular, in bathrooms with inherent construction methods such as mortar and tile, the thermal insulation performance may be significantly lower against the unit bath, which makes it difficult to increase the room temperature.
Therefore, both the drying and reserve heating performance may be significantly inferior to the case of a unit bath.
Please do not install the inner kettle bath in the bathroom.
Exhaust gas may cause backflow carbon monoxide poisoning in the bathroom.
Items that are embedded in the ceiling cannot be installed outside of the ceiling.
Depending on the construction and material of the bathroom, reinforcement of the ceiling may be required.
The wider the bath, the longer the drying time and the better the heating effect.
Wiring work should be performed by a qualified person, according to electrical equipment technology standards and internal wire regulations.
Please use D-type ground construction and installation of special electric circuit breakers according to electrical equipment technology standards.
When using a dedicated circuit breaker, please choose a high speed type with rated current 20A (rated current 15 mA, operating time less than 0.1 seconds) for overcurrent protection.
Please be sure to check with the jurisdictionary office for guidance standards regarding the installation of the fire prevention ordinary.
Do not use in hot springs. This may cause the product to malfunction.
Water droplets may fall off in humid locations such as bathrooms, but this is not a failure of the ventilation fan.
Please choose a place that is not uncomfortable for installation.
Please note: Order cancellations, returns, refunds and exchanges cannot be accepted. Please make sure to check with the installer to make sure the product is installed in place. If you have any questions, please contact the manufacturer customer center or our company