Equipped with 2 effect loops
Equipped with 2 independent effect loops,
Solo effects and rhythm effects
(For basic sound, special effects, etc.)
Prepare two different effects and
Less switching allows you to control more effects.
The loop is independent from the main line,
Vintage effects, etc.
With high noise and sound quality deterioration,
Integrates into your system without any issues.
Problems growing pedals
Many guitar players can find their way from vintage to the latest models
Use countless pedals to create your own tone
In the pedals, you can simply connect it to a noise source.
There are some severe sound quality deterioration, which is a major problem in the field.
As the effect increases,
It is also difficult to operate such as the foot and switch.
It will solve any problems when using these many effects.
Loopbone should be the center of the pedal board
It has a variety of functions and features to achieve a variety of sound.
Excellent sound quality.
Outstanding Sound Quality
Using the deterioration of the guitar signal or effect loop,
Equipped with a buffer to ensure the sound quality does not change.
The buffer has the effect of lowering the impedance and
It will not be affected by noise even when using long cables.
For lighting devices that often cause noise generation,
It has a tremendous effect on large stages around you.
If the quality of the buffer is not enough, the sound quality is sacrifice.
Many effect pedals can also be used for IC and
Comes with a buffered with an open amp.
ICs and operational amps are low cost and small in size.
Sound is not good.
Loopbone buffered
Discrete Class A circuit with good sound.
Therefore, you will not sacrifice sound quality.
Gain Booster
For the back of the effect loop
Equipped with Class A gain booster (up to 15dB).
Since it is behind the loop, the effect sound is intact.
Clean boosting.
Great for guitar solos or any other need to increase the volume.
Recreates sound by connecting the amplifier directly.
In general, when you connect the guitar directly to the amplifier,
Guitar pickup and amplifier inputs,
The sound will change due to the resistance caused by the cable.
The change is one of the reasons to make each amplifiers unique sound.
But when the bufferer goes in between
The connection between the guitar and the amplifier will be lost.
Loopbone is equipped with a buffer to eliminate noise.
Usually once the guitar signal is active,
The sound is different from when connected directly to the amplifier.
However, Loopbone has Drag controls.
Drag controls reproduce sound directly connected to the amplifier.
This control revives the unique relationship between guitar and amplifier,
Even if you build a loop system, you will get natural sound.
Independent tuner out
Most tuners are connected to the device for a high sound quality degradation.
What you want to avoid in effect systems.
Equipped with independent tuner outs,
Prevents sound quality deterioration caused by tuners.
Operate other devices
Loopbone makes it easy to use for amplifiers, headbones, etc.
Control products with Slingshot (remote input)
You can switch the amplifier channel at the same time you switch the loops.
You can switch the amplifier head with Headbone.
The Slingshot out can be used with various amplifiers and effects, etc.
For use with foot switch jack jacks,
You can set the control signal type, polarity, etc.
Specifications: