Independent control in treble and bass
Pedal allows you to separate signals from high and low to hang compressors on each side.
The compressor is professional grade with sound quality and control that rivals studio equipment.
It also has a loop for each band so you can drive or filter high and low bass power that is often lost by pedals, and it can be used for a variety of ways depending on your ideas.
Mix dry and wet sounds and balance each band freely
1. RATIO
Adjust the compression rate when the compressor is activated. The clockwise the higher the compressor ratio, the stronger the compressor will work.
2. RELEASE
Adjust the time for the compressor to finish The clockwise the longer the compressor works.
3. ATTACK
Adjust how fast the compressor will work. The more you turn the compressor clockwise the faster it starts to work.
4.THRESHOLD
Adjust the volume level that the compressor operates. The more you turn the compressor clockwise the smaller the sound.
5. GAIN REDUCTION LED
Visually displays the compressor effectiveness of the audio signal.
DC Jack 6.
Connects 9 volt DC power supply. The center is negative
7. PARALLEL
Blends original input signals and compressed input signals.
8. LO/HI MIX
Adjust the ratio of HI and LO compressed signals blended to output from OUTPUT. Functions as tone adjustment.
9. X/O FREQUENCY
Control determines what frequency input signal is separated and sent to high and low range.
10. INPUT
Connect your instrument or connect the output from another pedal.
11. HI ON/OFF
High frequency compressor on/off switch.
12. HION LED
High frequency compressor lamp.
13. LO ON LED
Low frequency compressor lamp.
14. LO ON/OFF
Low frequency compressor on/off switch.
15. MAIN OUTPUT
HI and LO signals are mixed and outputed.
16. LO/RETURN
Return the signal sent from the LO end to the external effector. When plugged into this jack, the LO end signal will be internally interlocked so the signal from this LO return is output from the main out.
17. LO/SEND
These terminals can be used for two applications.
One is the general effect loop. The high frequency band signal through the compressor connects from this LO end jack to the external effector and returns to the LO return jack. The second option is to use as a crossover pedal to send high frequency signal to another external amplifier. The internal signal will not be disconnected when connected to this jack, and it will be output from the main out.
18. HI/RETURN
Works the same as LO return in high frequency bands.
19. HI/SEND
Works the same as LO end in high frequency bands.
Model X2C
Input Impedance: 220KΩ
Maximum input level 2V
Maximum output level 2V
Gain width -16dB to +16dB
Noise - 85dBu (Level at Max)
Frequency Response 10 - 25KHz
Compressor Type: VCA Compression
Threshold 1:1 - 10:1
Attack - Release High Attack (400mS-20mS), Release (30mS-700mS)
LO Attack (1000mS-40mS), Release (200mS-2500mS)
Crossover Type 2D RC Divider 100Hz-500Hz
Power Supply, DC 9V Adapter, Center Negative 1000mA or More Recommended
Power Consumption: Up to 680 mA
Size 120(W) x 40(H) x 144(D) mm (not including protrusions)
Weight: 19.4 oz (550