[IAR & Remover Set]

[IAR Remover Single]

[IAR Single unit (HF1008)]

Fits 1500-6000 Special tool for removing and removing IAR equipped round abs such as Urkas, CSH, and UC. For small abs such as 1500, 2500, 3500, and the housing of the clutch spring will be slightly interfered, so it will need to be sharpened (about 1 minute for a tabletop grinder Homsen 2000 yen). In addition, since there is no pedestal on the drive shaft used during installation, a 4000-6000 drive shaft is required. As picture IAR is HF1008 (10-14-8) similar to 4000-6000. [Regarding Replacement] *Replacement tool is the best press, so those who can use the press. If you feel awkward, a vice is good. Clamps will not slip Hammers are exceptional. If you do not leave it vertically, you can twist the IAR housing and become a scattered when you install the new IAR. Be as slow and cautious. [Work Instructions] 1. Set the male and female of the detachable jig to secure it to a vice. 2. Rotate the vice slowly and remove it slowly. If you do not remove it vertically, it will become scattered when inserted, so please work carefully and slowly and carefully. Always check if the male jig is completely disappeared vertically. Vise is recommended for 2.4 inches (60 mm) or more. 3. When the male progresses, it becomes lighter and the genuine IAR will come off. 4. Set the new IAR in the right direction. Rotation direction is different between the right and left handle. Use IAR facing out Rotation direction is listed on the IAR body. 5. Insert the IAR from the side of the handle, hold it with your finger and push it into a certain extent. The IAR housing has been tapered for the handle side of 0.6 inch (14.2 mm) and the gear side is 0.6 inch (14.1 mm). Therefore, please be sure to insert it from the side of the handle. Stays in from the gear side. 6. Use genuine drive shafts, IAR sleeves, drags, spring washers, and other accessories of this product to press them in. Simply insert the included washer into the drive shaft, insert 2 IAR sleeves, and spring washers, and insert the drag to some extent, insert the handle and slowly tighten the drag. If you go to the deep, the IAR will fill the housing about 0.06 inch (1.5 mm). 7. Remove the IAR sleeve, insert the included collar, insert 2 spring washers, drag and handle and slowly tighten the drag. 8. Remove the drag when the drag is tightened to the end. 9. If the IAR is in the deep position, it will be put on and off safely pressure. 1. Assemble to make sure the handle turns normally or stops. Installation Notes: Do not use extreme pressure grease on IAR. IAR is a bearing that only turns in one direction, and when the extreme pressure grease is in this case, it will slip and reverse. After degreasing, use no refueling or use one-way grease (non-extreme pressure grease). Our store! 2500 Ways Together. Please try to work carefully and slowly. In addition, it is not an official product, and the technique of replacement is tangled, so please use at your own risk. If the vertical work is sweet, it will be slightly loose when inserting IAR. Fast Shipping