Can also be used on stocking type wader socks.Other fleece lining (Please note that when used with fleece lining, there may be some traces.)

The surface is made of polyester fabric and elastic wetsuit repair, and the new package (there is no difference in the product itself).jersey seam sheet.Same material as jersey seam tape and can be used with hot iron crimping. Thickness is about 0.49mm

Used on wetsuit inner jersey seams and seams, reinforced seam tape and seam tape intersections, repair and reinforce small scratches on jersey surfaces, holes and tears on jersey surfaces where seam tape cannot be repaired.

After bonding with a wetsuit bond, cut the seam sheet larger than the repair area for reinforcement and heat crimping to ensure a better repair.

*If the hole is punctured, water will enter the sheet alone.Please use a bond before reinforce with the seat.

Iron on dry setting, medium temperature about 10-20 seconds, but adjust the temperature and time according to the repair environment.After thermal pressing, the adhesive will be stronger when cooling.

*If it is damaged it will leave a sticky residue behind, but if you apply a press cloth and heat it like it was applied, the glue will be removed by the melt.

Too much ironing or too much temperature rises will be a burden on the fabric.Even if the temperature is too low, please adjust the temperature and time and apply heat crimping while checking if it is sticking to the surface.

Please repair the jersey side with each other.Avoid skins, pails, special fabrics, rubber surfaces or SCS.Heat may cause fabric to melt

Use an ironing board to lay the repair fabric flat as much as possible.For uneven surfaces such as uneven surfaces on the repair area, place the plaque under the fabric and apply heat.If the seam sheet is floating and may not stick well.

Clear glue protrudes from the side of the sheet when glued strongly

How to Use:

1. Clean the treated area thoroughly with fresh water and dry thoroughly.

2. Spread the fabric over the ironing board and place the cut seam sheet on the part you want to repair.

3. Place a thin cloth such as a handkerchief over the seam sheet and press with an iron to make sure the sheet does not move.

Iron Temperature

Synthetic fiber: Low temperature (approximate): 284°F (120°C).

Cotton: Low temperature (approximate): 392°F (160°C).

If the seam seat is not sticky, please raise the temperature slightly by bit.(Be careful not to overheat the temperature.)

4. Repeat work while making sure the seam sheet is firmly attached.

Please adjust the temperature of the iron while checking on the adhesive condition of the sheet, and then press the sheet tightly while pressing down on the sheet.

Use it with wetsuit bonds to secure the seam sheet to prevent water damage.(It does not have a waterproof function that prevents water from seeping in saltwater, just attach the seam sheet to reinforce the repairing area. )

May not stick well if the seam sheet is floatingBe sure to apply heat to the repair area and the entire seat.

Please glue the jersey side together.Avoid skins, pails, special fabrics, rubber surfaces or SCS.Heat may cause fabric to melt

The fleece lining can be pressed on the entire surface of the iron, and the brushed fabric will easily leave marks on the brush.After temporarily fastening the sheet in a short amount of time, please use only the iron tip with heat crimping.

For uneven surfaces, such as the repair area, place the blocks and fabric with a cushion, so that heat is exposed to the entire repair area and seat.If the sheet is floating it may not stick properly.

Store in a cool place away from sunlight.

You can refer to the product name link to the video while in use.