Feature

●1. Press the position where you need to insert the rotary lever and tighten the screws(Note: if there is a guide with the platform, do not screw it)
●2.Attach the gear lever to the swivel bracket and fitted swimsuit
●3. Put the motor into the water plate and pull the motor shaft in line and move
●4. Protect the active lever clockwise and pull out the motor gear


Description

This tool can remove gear size range; maximum diameter 10.8mm, 14mm gear height:
Motor Pinion Gear Puller Remover for Walkera RC Helicopter Motor
Brand: Walkera
Color: Silver
Material: Aluminum alloy
Application: To pull gear
Usage: R/C helicopter, R/C car
How to use motor pinion gear puller remover:
1) Choose the needle according to the size of the motor axis. Do not pull the teeth through the diameter of the large shaft using the motor with a small needle. Otherwise, thimble will break. Heat the rubberized gear first to dissolve the glue. Then extract your teeth.
2) Select the timeble you need, insert the sprocket swivel lever and tighten the screw (Note: eject pins on the platform, do not screw. Too tight.
3) Insert the tooth rod swivel rod into the gear holder bracket.
4) Attaches gear puller.
5) Insert the motor into the pulsator crossboard and move it to the motor shaft to align the ejector pins.
6) Rotate the lever action lever clockwise at a certain speed to pull out the motor gear.
7) The maximum outer diameter of 0.4 inch (11 mm) and the tooth height of 0.5 inch (12 mm).