Designed to connect to side frames with racing technology feedback
The diagonal (diagonal) shape adopts a hollow triple square structure for aluminum beam material, which is extremely lightweight and high rigidity. The original undercover can be attached to the original aerodynamic design.
Location: Center
Type: TYPE 10-point
Vehicle height data (with standard vehicles).
Front 24.2 inches (616
Rear 23.8 inches (604
Underbrace ground height
Front Genuine Reinforcement When Not Attached Under Brace: 4.3 inches (110 mm)
Front Genuine Reinforcement with Under Brace Attached: 4.3 inches (110 mm)
●Clearance data
From genuine reinforcement to underbrace is approximately 0.2 inches (5 mm).
Check with 658CC. TB.FF.5MT vehicles. *Genuine reinforcement is required.
·There may be cases where the ground height is not possible by installing this product. Please check the minimum ground height and car height before installation.
Depending on the vehicle, the minimum ground height of the vehicle itself is the lowest part of the vehicle. For that reason, please be careful of the mounting suspension to maintain a minimum of 3.5 inches (90 mm) above ground height required for safety standards and inspection guidelines.
The same is normal suspension and our suspension vehicles.
Vehicle inspections and periodic inspections must be met with the aforementioned, but only the user of the vehicle must include the responsibility of maintenance management.
The load clearance will be reduced after installation, so please be careful when driving.
Each measurement measurement is based on our companys measurement conditions. Please use this product as a reference as it may differ depending on the model and vehicle conditions.
·Please note that the minimum ground height data is the near dator with an underbrace attachment, and is not measured throughout the vehicle.
Please note that installing this product may cause difficulty in replacing engine oil, mission oil, etc.