★★★ If you write a review, you will receive a storage bag at a high probability ★★★
Product Contents:
1. 2 x Sliding Door Glass
2. Quarter glass x 2
3. 1 x Rear Glass
The front side is also available separately.
Compatible models:
★BAMOS JOBIO BAMOS HOBIO ABA-HM3/4 series, EBD-HJ1/2 series
★Activan GBD-HHH5/6 Series
Does not work with BAMOS ABA-HM1/2 series.
(Note) For cars with high mount stop lamps built in inside, it will fit nicely (cars with exterior rear poo mounted cars will not have unevenness in the interior glass, so there will be no gaps. )
Other grades can also be installed if the glass shape is similar to the above compatible models.
1. We cannot accept complaints or returns other than this product cannot be mounted.
2. Please do not use this product as it will affect your vision while driving.
3. This product is attached with a simple suction cup, so there may be a gap between the glass surface.
Please note that they do not completely block light and are not visible from outside.
4.If the suction cup is difficult to stick to the glass surface, it is better to add moisture to the surface.
5. When using smoke film, please pay great attention to the suction cups when removing or removing them.
Pull up the suction cup knob to allow air to enter and remove easily.
6. There may be some wrinkles due to the fabric or urethane foam weaving.
7. Privacy sunshade may have a slight sewing error of 0.4 - 0.6 inches (1.0 - 1.5 cm). Please be aware that there may be slight gaps.
1. This item is made-to-order, so please understand that we cannot accept returns or exchanges as stated in Amazons return policy. 2. This product is not compatible with dash cams. Please note that the sunshade may be installed by covering the top of the sunshade, but we cannot accept returns or exchanges due to the reason it is not possible to install it because it has a dash camera. 3. This product is attached with a simple suction cup, so there may be a gap between the glass surface. Please note that they do not completely block light. 4. If there is a hot wire on the glass surface, antenna wire, car inspection seal, etc., it will interfere with suction cups, please install the base seal for suction cups (sold separately). 5. Suction cup may be deformed when opened. If it is deformed, put it in warm water about 140°F (60°C) for 5-6 minutes, it will return to its original shape and restore its suction power. 6. There may be some wrinkles due to the fabric or urethane foam weaving. 7. Privacy sunshade may have a slight sewing error of 0.4 - 0.6 inches (1.0 - 1.5 cm). Please note that there may be slight gaps. 8. The windshield is angled to make the sun shade easy to sag Pull up and down while wearing. (Note) This product is a "rear set". Please note that the front set is sold separately. The front and rear parts are displayed in the product images but are not a full set