Product Contents:
1. Windshield x 1 (Fits Sumasi 3)
2. Side door glass x 2
3. 1 x Stereo camera without cover
Note: When installing the front sunshade, please remove the vibration prevention rubber on the back of the rearview mirror before attaching it.
(Note) Smart Assist 2 "Monocular Camera" option. Please be aware that when installing a car, there will be a large gap between the front and the left and right of the windshield.
Sliding rear hatch is also available separately.
Compatible models:
★High Jet Cargo 321/331 Series
★Atray Wagon 321/331 Series
★Pixis Van S321M/331M EBD-S321M HBD-S321M EBD-S331M BD-S331M
★Sunburban 321/331 Series EBD-S321B HBD-S321B EBD-S321Q EBD-S331B HBD-S331B EBD-S331Q
★DIA WAGON S321N/331N ABA-S321N ABA-S331N
Other grades can also be installed if the glass shape is similar to the above compatible models.
When installing the front sunshade, it is convenient to secure it with the sun visors on the driver and passenger.
This product is compatible with Smaasi 3. Cover parts are compatible with cars without stereo cameras. When installed on Smaasi 2, there may be gaps near the monocular camera and may not fit well.
1. We cannot accept complaints or returns other than this product cannot be mounted.
2. Please do not use this product as it will affect your vision while driving.
3. This product is attached with a simple suction cup, so there may be a gap between the glass surface.
Please note that they do not completely block light and are not visible from outside.
4.If the suction cup is difficult to stick to the glass surface, it is better to add moisture to the surface.
5. When using smoke film, please pay great attention to the suction cups when removing or removing them.
Pull up the suction cup knob to allow air to enter and remove easily.
6. There may be some wrinkles due to the fabric or urethane foam weaving.
7. Privacy sunshade may have a slight sewing error of 0.4 - 0.6 inches (1.0 - 1.5 cm). Please be aware that there may be slight gaps.
8. The windshield is angled to make the sun shade easy to sag Pull up and down to wear
1. This item is made-to-order, so please understand that we cannot accept returns or exchanges as stated in Amazons return policy. 2. This product is not compatible with dash cams. Please note that the sunshade may be installed by covering the top of the sunshade, but we cannot accept returns or exchanges due to the reason it is not possible to install it because it has a dash camera. 3. This product is attached with a simple suction cup, so there may be a gap between the glass surface. Please note that they do not completely block light. 4. If there is a hot wire on the glass surface, antenna wire, car inspection seal, etc., it will interfere with suction cups, please install the base seal for suction cups (sold separately). 5. Suction cup may be deformed when opened. If it is deformed, put it in warm water about 140°F (60°C) for 5-6 minutes, it will return to its original shape and restore its suction power. 6. There may be some wrinkles due to the fabric or urethane foam weaving. 7. Privacy sunshade may have a slight sewing error of 0.4 - 0.6 inches (1.0 - 1.5 cm). Please note that there may be slight gaps. 8. The windshield is angled to make the sun shade easy to sag Pull up and down while wearing. (Note) This product is a "front set". Please note that rearsets are sold separately. The front and rear parts are displayed in the product images but are not a full set