Feature

●1.ABS casing and adding new package, save money compared to many customers who use 3D printed housing
●2. Support typec-typec line, connect the phone more convenient, support most phones with the same screen display. Solve the problem of small screen and lack of brightness
●3. Support time domain analysis function (TDR)
●4. Can show the usage of the battery on the interface
●5. The product serial number is on the back


Description

6. Exterior, world cover hot stamp carton, plastic inner protection. Reduces trouble caused by impacts during shipping.
7. Other details have been improved.
Specifications:
- PCB: 54mm x 85.5mm x 11mm (excluding connector and switch size)
- Measuring frequency:
10KHz - 1.5GHz
- RF Output: -13dbm (max. -9dbm)
<;0.5ppm
- Measurement range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) Enable Extended firmware)
<; 1.1
- Display: 2.8" TFT (320 x 240)
- USB Interface: USB Type-C; Communication Mode: CDC (serial)
- Power Supply: USB 5V 120mA, built-in 650mAh electric, maximum charging current 0.8A
- Number of calibration points: 101 (fixed)
- Number of Scan Points: 101 (fixed)
- Display Tracking: 4, Marking: 4, Setting: 5
Measurement of S parameters, voltage fixed wave ratios, phase, delay, smith charts etc.
Package List: 1X VNA Host(Includes 2.8 inch touch screen and 650 mAh battery)
2X 20cm SMA Male to Male RG174 Cable
2X SMA Female to Female Connector
1X SMA Simple Calibration Kit Short
1X SMA Simple Calibration Kit OPEN
1X SMA Simple Calibration Kit LOAD
1X USB Type-C Data Cable
1X Type-c to Type-c Line
1X Touch Paddle