Specifications: PCB: 54mm x 85.5mm x 11mm (Without connector, switch)
Measuring frequency: 50KHz - 1.5GHz
RF Output: -13 dbm (max. -9 dbm)
Measuring range: 70dB (50kHz-300MHz), 60dB (300M-600MHz), 50dB (600M-900MHz) (Extended firmware ensive);
<; 1.1
Display: 2.8 inch TFT (320 x 240)
USB Interface: USB type-C Communication Mode: CDC (serial)
Power supply: USB 5V 120mA, built-in 400mAh battery, maximum charging current 0.8A
Number of scanning points: 101 (fixed)
Tracking Display: 4, Markings: 4, Settings: 5.
Measurement of S parameters, voltage fixed wave ratios, phase, delay, and smith chart...
Update: 1 Low power noise, less noise during harmonic use.
2. Built-in 400mAh battery
3. Add a MicroSD card for convenient storage of test data (MicroSD supports up to 32GB, only support SPI mode)
4.Add RTC support
5. Change the port name to Port1 and Port2.
Package List:1X VNA Host
1X USB Type C Data Cable
2X 30cm SMA Male to Male RG174 RF Cable
1X SMA Simple Calibration Kit
1X SMA Female to Female Connector
1 x Stylus Pen