[Kit1]

[NanoVNA-F]

6. Full touch screen design with 3 side buttons at the same time, flexible and convenient operation.
7. Support Chinese and English interface.
8. Optimized UI design for user to perform measurement operations.
9. Support screen brightness adjustment.
10. Firmware can be upgraded via virtual U disk. No programmer required. Firmware can be upgraded via the included USB Type-C data cable.
11. Standard high quality calibration components and RG405 phase stabilization cable ensure accuracy of calibration.
12.The USB power output interface is designed to support 5V/1A power output.
13. Uses 2A large current charging IC, reducing charging time.
14. The host computer support host computer software, support Chinese and English interface.
15. The screen image of the device can be obtained by obtaining a screenshot of the host computer.

Dimension: 14CM * 7.5CM * 2CM (length, width, height)
Measuring frequency: 50kHz-1000MHz
RF Output: - 13 DBM (max. - 9 dBm)
<; 0.5 ppm
<; 1.1
Display: 4.3" IPS TFT (800x480)
USB Interface: USB Type-C Communication Mode: CDC (serial)
Power consumption: USB 5V 200mA, built-in 5000mAh battery, theoretical life 18 hours, maximum charging current 2A
Number of Scan Points: 101
Tracking Display: 4, Mark: 4, Settings: 5.
Scan time: about 1.9 seconds per hour (50kHz-1000MHz full frequency band)
Measurable S parameters, Voltage Constant Wave Ratio SWR, Phase, Group Delay, Smith Circular Diagram...

- Item Name: NanoVNA-F V2 Analyzer
- Color: Black
- Measuring frequency: 50KHz -3GHz
- Display: 4.3 inch, resolution 800*480
- Battery: 5000mAh Li-ion battery
- RF output power: -9dBm (within 1GHz: ±1dB)
<;0.5ppm
- S21 Dynamic Range: 70dB (1.5GHz), 60dB (3GHz)
- S11 Dynamic Range: 50dB (1.5GHz), 40dB (3GHz)
- 2 Port Return Loss: 20dB typ (1.5GHz), 13dB min (3GHz)
Number of calibration: 101
Number of scans: 101
- Tracing: 4
Number of impressions: 4 (Stamp bar can be moved down on the screen)
USB Interface: USB Type-C Communication Mode: CDC (serial)
- Settings save: 5 groups (call directly after storage, next use, no need to re-calibrate, parameters stored before last shutdown are automatically launched at the next time power on)
- Supports calibration results interpolation, after adjusting the measurement frequency band and can be measured without recabilitation
- Scan time: about 1.9 sec/1 time (50kHz ~ 3000MHz full frequency band)
Can measure S parameters, voltage fixed wave ratios, miss charts, phase, group delay, etc.
Package Includes: - 1 x Host
- 1 x SMA Open Circuit Calibration Parts
- 1 x SMA Short Circuit Calibration Kit
- 1 x SMA 50 Load Calibration Kit
- 1 x SMA-KK Double Head Female Adapter
- 1 x SMA-JJ Double Head Male Adapter
- 1 x SMA-JKW Elbow Female to Male Adapter
- 2 x 20cm SMA-JJ RG405 Cable