Specifications:
Continuous Operating Time: 10 minutes
Suitable for discharge equipment: Single row: toilet; multi-row toilet+washb+ urinal
Drainage Mode: Lower drain (left row) + Lower drain (right row) (consult if upper drainage is required).
Input Power: 500W
Speed: 2900rpm
Flow Rate: 3-5m3/h
Body Material: Imported TSPC
Flashing Method: Smashing and discharging
Discharge Distance: 164.4 ft (50
Working mode: Automatic intermittent interval
Cooling Method: Pumping cooling
Drain diameter: 1.3 inches (32 mm)
Size: L18.1 x W7.5 x H10.2 inches (460 x 190 x
Lifting Height: 16.4 ft (5 m)
Water inlet: WC+2
Automatic sewer for various room types
Solves laundry toilets and sewer problems in one unit
Video Show:
Construction Disassembly Instructions
1. Left and right sewer outlets: Convenient side connection is optional, sewer pipe uses standard 32mm PVC water supply pipe. The height of the sewage that lifter expands to be more than 3 meters. If you need to attach the elbow to your pipeline, you should use two 45 degree bends instead of a 90 degree elbow. Horizontal shipping pipes require a slope of 3% or more
2. Left and right bathroom equipment supply outlets: optional convenient side connection, all facilities use 32mm PVC water supply and drainage pipe, bathroom fixtures require 3% slope, 322 can be connected to urinal/washbasin/bidet equipment, 322-N high power can be connected to shower room/bathtub/laundry equipment, etc. The risers have a soft connection and the connection is clamped tightly. All bathroom fixtures drain is at least 250 mm higher than the bottom of the lifter (based on where the lifter and toilet are installed on the same finished surface of the bathroom). Set up lifters, toilets and ensure bathing. The bottom drain height of the interior finish surface is over 250mm (bathroom finish surface height is 0).
3. Toilet Drainage Connection: All connected toilets are (wall drain/rear drain/horizontal drain), the center of the toilet drain is between 7.1 - 7.3 inches (180 - 185 mm) from the ground, the connection method is the toilet drainage. The mouth is directly inserted into the lifter 90mm rubber interface.
4. Toilet Water Supply Valve: The valve supply uses a standard DN15 (4 tubes). Furthermore, the hose connecting the toilet inlet valve and the water supply valve is 15.7 inches (400 mm).