Hand press knitting pieces: Head diameter 0.3 inch (7 mm), medium and double sided clamps for both sides of the head diameter 0.3 inch (7 mm) is a hand press jig. Made in Japan with tempering applied to SK steel to achieve high strength. *Please note that hitting pieces do not work as a tool alone. This product does not come with hand press. Please make sure to check the size of your hand press installation before purchasing. *Depending on the type of cash, the small parts of the pieces and tools do not fit together and may be the same number (size). In such cases, this product is consumable and cannot be refunded. In addition, depending on the timing of purchase, specifications may differ from those shown in the images. No problem with use. Please acknowledge Handpress Hammer Characteristics: The knitting pieces are available in 6 different head sizes (0.14 inch (3.5 mm) mini clamper, 0.18 inch (4.6 mm) extra-small clamper, 0.2 inch (6 mm) small clay, 0.3 inch (7 mm) medium clamper, 0.4 inch (13 mm) extra-large casme), and foot shape type (2 mm) Choose the hitting pieces according to the clamps The hitting pieces are paired with the "upper piece" with screws and "lower pieces" shaped like a mortar. For one side, a "pin" is shown from the lower piece. The "pin" features a spring mechanism to retract when pushed. For both sides, there are indentations in the center that corresponds to the shape of the foot umbrella. (How to install the clamps using hand press knits) 1. Choose the cutout that matches the thickness of the leather or cloth. 2. According to the thickness of the foot shaft, drill holes in the leather (cloth) to attach it. 3. Set the hitting pieces in the hand press. Secures upper and lower pieces to prevent them from sliding. 4. Place the bottom piece in the hole of the leather (cloth) to attach it. For one side, place the ankle feet on the top of the pin. For both sides, you can place your feet on the indentations. 5. Place the head on the head in a form of pinching leather (cloth). 6. Gently lower the lever down and cling. Once the clamps are crushed, they are done. This product is used as consumables. Please note that if you buy it by mistake, we will not accept refunds or exchanges. Please be careful when handling this product. Be careful not to damage or bend the tip by mistake. Hand press should be used on a horizontal surface.
Please note that all tools are consumable and will not be able to return the item if purchased by mistake