Hand Press Strikes: For 18 stainless steel grommets. This product is made to strike stainless steel (SUS304). Therefore, the tools are made not to extract the metal of the material, but they are also covered with resin rubber and do not stick directly to the stainless steel grommets. *Depending on the timing of purchase, the product may differ from the posted picture, but this does not affect the use of the product. Please acknowledge *This is a hitting piece that can be set on hand press and hitting 18 stainless steel grommets. Please note that hitting pieces do not function as a tool alone. This product does not come with hand press. Please make sure to check the size of your hand press installation before purchasing. *Depending on the type of grommet, the small parts of the pieces and tools do not fit together, but the same thread count (size) may not be compatible. In such cases, this product is consumable and cannot be refunded. We appreciate your understanding. (Features of hand pressed hitting pieces for grommet 18 stainless steel) Stainless steel SUS304 is made of high hardness steel, so it is difficult to install if you are not having strong force. The 18 stainless steel eyelet hammer features a metal base with a resin spring-loaded cushion, and is designed to crush while absorbing impacts The black part is designed to be direct against the piece with the grommet contact. Place 18 grommets in the lower piece, cover the leather from the top and then cover the washer from the top. Set the main unit, cloth, and washer, and lower the lever. Once the eyelet is turned back into a round shape, you are done. This product is "Hammer Pieces: For 18 Stainless Steel" with a round crimp type that does not break the tip of the grommet, creating a rounded and even border around the edge of the grommet. The back has a thin rim ring. (Installation Method of Grommet 18 Stainless Steel) The simple flow of work is the same method of hammering grommet using a hand press machine. Set the hitting pieces into the hand press machine, place the eyelet on the lower piece, and drop the upper piece with the lever and crush it. 1. Mounting pieces on leather or fabric: Drill a 0.2 inch (6.5 mm) hole for drilling etc. 2. Pass the foot of the eyelet through the holes in the first place. 3. Place the fabric over the main body of the eyelet to release your feet. Make sure your feet are 2-3mm off the cloth. 4. Squeeze from the top with a hand press machine with the pieces installed. 5. Finish The back is shaped like a small ring pressed into the loop and the surface is bordered with a doughnut-like loop. This product is used as consumables. Please note that if you buy it by mistake, we will not accept refunds or exchanges. The tip of this product is made of very thin metal, so please handle with care. Be careful not to damage or bend the tip by mistake. Hand press should be used on a horizontal surface.
Please note that all tools are consumable and will not be able to return the item if purchased by mistake