Feature

●Compatible Printers: Canon PIXMA TS8010 TS9010 TS8020 TS9020 TS8030 TS9030 TS8040 TS9040 TS8050 TS9050 TS8060 TS9060 TS8070 TS80 TS908 0 TS8090 TS9090 TS9055 TS8051 TS8052 TS8053
●Equipped with a protective cover to prevent damage to the internal structure, you can replace the original printhead and print your photos, documents
●Please make sure your printer is working properly before installing new printhead Otherwise, the motherboard may burn out and the printer will not be printed. The printhead needs to be used with the appropriate ink. Do not mix dye and pigment ink
●Each printhead is rigorously tested and tested for effectiveness using print test paper, this is a perfect replacement for the old single black printhead and is very easy to use
●This product is a third party product and is not an official product. Also available in black only. Please acknowledge
●【Error B203 Solution】1.Turn off the printer, press the "Stop" button first, then press the "Power" key immediately (do not release both buttons). 2. When the power light is on, do not release the power button at the same time, release the stop button, then press the stop button 5 times to release the power button. 3. If the power indicator is long enough, the maintenance mode is entered successfully, the computer device detects the hardware, and the zero adjustment software detects and identifies the printer type, completing the software zero adjustment


Description

Material: ABS.

The head of the printhead is very fragile, so please protect it without collision. The surface is a single piece of aluminum and the inner layer has a crystal oscillator and a small ink tube. Touch will dent, deform or break

When installing the nozzle, be sure to turn off the power and place it in place. After installation, please do not use your hand to gently press the trolley around to test whether it is smooth, because if the head is not in place, the trolley is easy to move the head into the crack, while the human hand has a feeling of freedom to put away from the human hand and it is controllable.

When connecting the plug cable, do not pull out the ink and contact the socket firmly and do not touch the foot. Otherwise, the printhead will be shortened and burned.

● The steel shaft should also be clean and smooth, it can be wiped with a bit of paper towel adhesive lubricant, do not add oil directly to the shaft, the excess oil will flow into the nozzle and cause damage.

Check the water circuit after the machine and electrical circuit is properly operated. First, you need to make sure the water in the cartridge is enough and then the small cleaning scraper and ink suction pump are clean and clean.

● Just after the head of the air that is directly attached to the printhead so that it will not print normally after the head of the air that is normally fully discharged from all lines immediately; First all available intermittent cleaning (only 2 times once and 30 minutes after cleaning 2 times and stop 30 minutes after cleaning). No need to remove cleaning pump ink, print mixing, ink leakage. Not made Next, you can print a lot of images like a printhead when the machine is connected to a waste tube first, turn off the power and use the rubber tube syringe set until 3-5 ml of ink is pumped out, then use the rubber tube syringe set to the pump with a regular cleaning machine that is comparable to that of air from the head, and the side effects can easily cause the ink cleaning pump.