Specifications:
Type: Non-insulated Boost Module (BOOST)
Input Voltage: 10 - 32 VDC
Input Current: 16A (max) If the above 8A, please increase the heat dissipation.
Current consumption: 15mA (tested when converting 12V to 20V. Higher output voltage will increase)
Output Voltage: 10 - 60 VDC continuous variable
(It only applies when the input voltage is lower than the output voltage. cannot be buck pressure.)
Output current: 8A (relating to the difference in input voltage and output voltage, the higher the voltage difference, the smaller the output current); If the current is above 4A, please increase the heat dissipation.
Constant Current Output Range: 0.3-8A
Turn light adjustment range: 0.3 - 8A
Output Power: Natural Cooling 90W MAX Enhanced cooling 150WMAX
Operating Temperature: -40°C to 85°C (If the temperature is too hot, please increase the heat dissipation)
Frequency: 150KHz
Conversion efficiency: 95% (efficiency involves input/output voltage), current and voltage difference)
Short circuit protection: Yes (input 15A fuse)
Reverse Input Protection: No, normally you can connect the diode in series to the input.
Display lamp: With charging indication Red for charging, Green indicates when fully charged.
Output flow back protection: Yes
Installation Method: 4 x 0.1 inch (3 mm) screws (sold separately).
Wiring Method: Terminal Block
Weight: 74g / 2.6oz (approx.)
Package List:
1 x Voltage converter.
Current adjustment:
1. Adjust the CV potentiometer according to the load requirement, and adjust the output voltage to the appropriate value. Example: 4 Series 55V Batteries, 10 Series LED 37V
2, The output current value of the module is set to the minimum (rotate the CC potentiometer counterclockwise until you hear a small cracking sound from the potentiometer)