JH-M609 Voltage Protection Module 6-80V High Voltage Digital Display Overdischarge Circuit Protection Board Voltage Protection Module
Features:
Voltage Calibration: The input terminal is connected to 30VDC (30V voltage only) The two solder joints in the upper right corner of the display need to be calibrated at least 1 second. The digital display stops after the CA-L flashing.
Stop setting ≤11V, ≥14V ≥15V Stop
Opens in a range of 10.5V to 12V and closed(stop at low voltage ≤10.4V and stop at high voltage ≥12.1V).
Over Voltage Setting Range (HV Key):6-80V- No Limitation(Display--),Factory default is unlimited. In addition, the overvoltage must be larger than the release voltage. If you cant set the "+" or "-", please check the HV key to make sure the setting value is appropriate.
How to use: Due to battery overdischarge voltage settings, different loads, the cutoff voltage is also different. Measure the cut-off voltage value according to actual use. The precondition is that the cutoff voltage must be bigger. Battery over discharge voltage
Specifications:
Name: Battery Voltage Protection Module
Model: JH-M609
Power supply voltage: DC6V-80V
Output Voltage: Same as Supply Voltage, DC6V-80V
Max Input: DC80V (Note:
Input voltage above 80V may be damaged permanently)
Control accuracy: 0.1V
Power consumption: less than 1.5W
Protection Function: The positive and negative polarity of the input terminal voltage is reversed, automatic protection, no display or output. (Note:
If the input connection is correct, the output terminal connection is reversed, the output terminal will not be protected.
Display Mode: 3 Position 0.36" LED Digital Tube
Display Color: Red
Material: PCB board
Size: Approx. 57x42mm/2.24x1.65"
Application:
Compatible with all electric motorcycles and tricycle batteries