Feature(may vary by option.)
●(Single Color/Mixed Color Emitting Modes) Single color is mixed with 3 different colors: red, green, and blue. When single or mixed color is glowing, you can adjust the brightness by pressing the remote control "↑↓" button
●Pattern Emitting Modes: Equipped with various types of flash, strobe, fade, smooth and more. During the light of the pattern, you can adjust the speed of movement by pressing the remote control "↑ buttons
●The back has double sided tape. The back of the LED strip has double sided tape for immediate use
●Specifications: LED Specifications: 5050 3-chip LED/Input Voltage: DC 12V / Board Color: White Base / Emitting Color: RGB (Full Color) / Power Consumption: Approx. 5.4W / Current Value: Approx. 0.45A / LED Quantity: 30 lights (3 LEDs in 2 cm increments) / Waterproof: Tape Light Body Only / Cut Line: Can be cut every 2 inches (5 cm) / Tape Length: 5000 cm) / Tape Width: 19.7 cm / Tape Width: 19 cm Approx. 0.4 inch (10 mm) / Thickness: Approx. 0.1 inch (2.5 mm); Cable Length: Approx. 2.0 inches (5
●Specifications: Input Voltage: 5V - 24V / Connector: Flat 4 Pin to 5.5 - 2.1 Jack / Cable Length: Approx. 3.9 inches (10 cm) / The pin has polarity (positive / negative ) (if you insert a pin without light up, please change the direction of inserting it in. Specifications: Remote Control / Key Type: 24 keys / Remote Control Size: Height: Approx. 3.1 inches (8 cm), Width: Approx. 2.0 inches (5 cm), Thickness: Approx. 0.2 inches (5 mm)
[50cm]
Description
[Note]
Simple instructions are included.
We cannot answer any product details other than listed information.
This product is a single LED strip light.
Specifications such as color and brightness may differ depending on the lot.
We do not accept returns or exchanges for reasons other than initial defects such as differences in color from your imagine.
The waterproof performance of the LED tape light is equivalent to daily waterproofing.
Not intended to withstand submersion or outdoor use.
The joint part of the controller and the tape light (4 pin) are very delicate.
Please be careful when laying out like hanging from the controller part as it will release it with light force.
Specifications may change depending on the lot.
The pin on the receiver has polarity (positive and negative). If the pin does not light up even if it is inserted.
Turn the plug and connect.