Feature(may vary by option.)
●(Low voltage startup) The wind turbine charge controller can be activated at low pressure with breeze and sufficient energy. MPPT Boost Charging Technology is used to solve the problem of the fan slower and unable to charge
●Waterproof/Dustproof: The charging controller of the wind turbine is waterproof, dustproof, and heat-conductive silicone filled seal, which is durable and abrasion resistant, and can be used in harsh environments
●(Versatile Protection) The charging controller of the wind turbine generator is perfectly equipped with overcharge protection, reverse polarity protection, short circuit protection, and high temperature protection, so you can use it with confidence
●(Advanced Technology) The higher the energy conversion rate of the wind turbine controller, the better the charging capacity and the efficiency of the generator system
●(Wide Range of Applications) The charging controller of the wind turbine generator is suitable for most regions of the world, and can be automatically identified and adjusted to switch between 12V and 24V voltages
[5 Pcs 12-🐭ß]
[12-♒ß]
[2 Pcs 12-🐭ß]
Description
Product Description:
1. Control the wind turbine and charge the battery automatically.
2. Modular design to ensure maximum performance throughout the system
3. Adopts a fully sealed and completely waterproof design, the protection grade is IP67 and above.
4.Using MPPT Boost Charging technology, you can start when the wind is weak and energy is enough. This solves the problem of fan slower and unable to charge
PREVENTION:
1. Make sure the output voltage of the wind turbine matches the voltage of the battery.
2. Wire in the following order. First connect the battery positive and negative pole, then connect the fans three-phase voltage output.
3. Please connect the battery and wind turbine to the controller strictly according to the instructions. Reverse polarity or wrong connection can cause system malfunctions and completely damage the controller.
Parameter:
1, Max Input AC Voltage: AC35V;
2, Output DC Voltage: DC12V / 24V;
3, Battery Charging Cut-off Voltage: DC14.5V ± 0.3V / 29V ± 0.3V;
4, Max charging current: 15A (12V) Max charge current: 10A (24V);
5, Wind generator speed limit voltage DC14.5V ± 0.3V, 29V ± 0.3V;
6, Protection level: IP67;
7, Static power consumption: 0.008A;
8, Bearing Power: 400W;
9, Max bearing wind speed: lvl.12;
10. Working temperature: -35°C - 65°C
11, Input Wiring: 3-Wire System;
12, Control mode: 12V/24V compatible;
13, Installation Method: Bolt-On
14, The wiring is shown in the model diagram. Please do not reverse the positive and negative poles to avoid the controller burn.
Product List:
Wind turbine controller x 1