Feature(may vary by option.)
●(Enough Energy) The charging controller of the wind turbine generator has sufficient energy and can solve the problem of uncharging the fan due to slower rotation speed. MPPT Boost Charging Technology allows you to start at low pressure with a little wind
●Long life: Heat conductive silicone filling and sealing, IP67 waterproof, dustproof, oxidation resistant, durable and wear-resistant, can be used in extreme environments of -35C to 65C
●Safe and Convenient: The wind turbine controller is completely equipped with overcharge protection, reverse connection protection, short circuit protection, and high temperature protection, making it safer and more convenient to use
●(Upgraded Technology) Compared to traditional PWM charging controllers, the charging capacity and power generation system utilization efficiency and energy conversion rate
●Wide Range of Applications: The charging controller of the wind turbine automatically identifies the voltage of 12 V and 24 V and can be adjusted and switched for a wide range of applications
[12-♒ß]
[2 Pcs 12-🐭ß]
Description
Product Description:
1. Control the wind turbine and charge the battery automatically.
2. Modular design to ensure maximum performance throughout the system
3. Adopts a fully sealed and completely waterproof design, the protection grade is IP67 and above.
4.Using MPPT Boost Charging technology, you can start when the wind is weak and energy is enough. This solves the problem of fan slower and unable to charge
PREVENTION:
1. Make sure the output voltage of the wind turbine matches the voltage of the battery.
2. Wire in the following order. First connect the battery positive and negative pole, then connect the fans three-phase voltage output.
3. Please connect the battery and wind turbine to the controller strictly according to the instructions. Reverse polarity or wrong connection can cause system malfunctions and completely damage the controller.
Parameter:
1, Max Input AC Voltage: AC35V;
2, Output DC Voltage: DC12V / 24V;
3, Battery Charging Cut-off Voltage: DC14.5V ± 0.3V / 29V ± 0.3V;
4, Max charging current: 15A (12V) Max charge current: 10A (24V);
5, Wind generator speed limit voltage DC14.5V ± 0.3V, 29V ± 0.3V;
6, Protection level: IP67;
7, Static power consumption: 0.008A;
8, Bearing Power: 400W;
9, Max bearing wind speed: lvl.12;
10. Working temperature: -35°C - 65°C
11, Input Wiring: 3-Wire System;
12, Control mode: 12V/24V compatible;
13, Installation Method: Bolt-On
14, The wiring is shown in the model diagram. Please do not reverse the positive and negative poles to avoid the controller burn.
Product List:
Wind turbine controller x 1