Feature

●★ This product uses a maximum output of 1800 W, super layout design and super heat sink, good heat dissipation, and has a cooling fan interface, so it can be used to discharge Tesla and generator voltage inverter. <br/>This induction heating circuit uses 12-48V low voltage DC power supply, maximum current 40A, maximum power 1800W. <br/>We also use graphite urns for gold, silver, copper, aluminum, and sleeves
●★Although the minimum input voltage of the module is 12V, it does not mean that all 12V power supply can be used, some novice buyers may use smaller power supplies. This module has specific voltage and current requirements. Voltage 12V current must be more than 10A. Power supply available. If the power is too low, the output will be greatly reduced. If the voltage is lower than 12V, 2
●★ The induction heating capacity is large, so the heat generation is normal, so please use sufficient cooling. <br/>For inductive heating, we recommend switching power supply that exceeds 48V 50A. Power supply above 24 V and then over 20 A power supply, the voltage is bigger, the current is bigger, the heating power is bigger, and the heating power is bigger
●★ Continuous operation with good heat dissipation. Due to the moderate output, it can be used by DIY players to harden, harden, and other heat treatments to handle parts. <br/>In this test, the maximum power is close to 1600 W, and the maximum current is 35 A. This product can be used under conditions with good heat dissipation, and the utility model can be used continuously for several hours
●★ If you see the heat generating of MOS tube, first consider whether the output meets the requirements. <br/>Do not empty the board. When empty, it produces very high frequency noise and burns out the MOS tube. <br/>We recommend using a 36V 20A power supply for inductive heating. The 12V power supply is too small and the heating is almost unreacted, and the 12V power supply is easy to reduce the power output voltage, 12


Description

2000 Watt 50A ZVS Induction Heating Board Heater Module Flyback Driver Loss

Brand new and high quality.
Features:
This product adopts a maximum power of 1800 W, Super PCB layout design and super heat sink, with cooling fan interface, good heat dissipation, can be used for Tesla discharge, generator voltage inverter etc.
This induction heating circuit uses a low voltage of 12-48V for DC power and a maximum current of 40A and the maximum power is 1800W.
Continuous operation is possible if heat dissipation is good. Due to the moderate output, it can be used by DIY players to harden, harden, and other heat treatments to handle parts.
It can also be used to melt gold, silver, copper, aluminum and other metals using graphite urns, heat evenly and quickly and very convenient.
In this test, the maximum power is close to 1600 W, and the maximum current is 35 A. This product can be used under conditions with good heat dissipation, and the utility model can be used continuously for several hours.

Note:
1. Heating power is very large, except the plates and parts are hot and the copper tube is very high. The buyer can prepare water cooling system separately, and it can purchase a small water pump and 6.6 ft (2 m) rubber hose with an inner diameter of 0.2 inch (4 mm).
2. When using the switching power supply, the high output switching power supply usually has a soft start function, the output voltage will rise slowly, so you should pay attention to the voltage rises to 10V before the connected induction heating circuit occurs. If the voltage is insufficient, the circuit will vibrate and two M