Installation:
1.Clean your cluster screen with a microfiber cloth to remove dirt and dust.
2. Remove the liner labeled with Step 1. (Please make sure the film does not have a clear liner)
3. Spray plenty of water on the adhesive surface with the liner fully removed.
4. Light up the screen protector with a button or edge and gently place it on the cluster.
5. Squeeze the water and air pocket gently Try to remove as much water and air as possible.
6. Remove the liner labeled with Step 2. (Make sure the film is perfectly aligned and no top liner.
7. Remove excess air pockets and water and complete the process. Congratulations! The cluster screen is fully protected with our product.
Notice:
-Please make sure it matches your model.
▶Package Includes:
Set of 2 (Cleaning Kit with Squeegee)
▶Installation Method:
1. Use the fiber cloth in the package (clean wet cloth) to remove dust and dirt from the speedometer screen.
2. Spray the right amount of water on the speedometer screen (best to use detergent and water mixture water to make sure the position of the protective film is properly adjusted).
3. Peel off the No.1 surface film of the protective film, then carefully paste the protective film onto the bike speedometer screen. After adjusting the position of the protective film, use a hard card (small) to squeeze out excess water and air. White card in package)
4. After squeezing out excess water and air, wipe the moisture on the end of the speed meter, finally peel off the second surface film of the protective film and finish installation. (Note: Do not erase speedometer screen within 3 days)
▶Note:
If you have any questions,please contact us,thank you