Feature(may vary by option.)
●デュアルパワー自動転送スイッチは、絶縁性と高温耐性に優れた難燃性PC素材と、老化防止で取り付けとメンテナンスが簡単な銀製接点で作られています。
●自動転送スイッチは、電源の連続性、コンパクトな構造、信頼性の高い伝送を確保するために、自動または手動で操作できます。
●常時電源供給：自動切替スイッチが作動し、通常電源に異常が発生した場合には直ちに待機電源が動作し、電源の継続を確保します。
●通常電源がオンの場合は、バックアップ電源から通常電源に自動的に切り替わります。
●広く使用されている：自動転送スイッチは、抗干渉、自己投げおよび自己繰り返しタイプであり、連続停電が許可されていないさまざまなシナリオ、家族、ショッピングセンター、工場、研究所、農場などで使用されます。
[2 63A]
Description
RP6-63H is terminal type ATS. Its suitable for 3 phases 4 wires (or 1 phase 1 wire) dual power grid with AC 50/60Hz, rated voltage 400V/230V and rated current up to 63A. When one power goes wrong (only test normal Phase A voltage and reserve Phase A voltage, only test loss voltage or loss phase),it will automatic connect one or several load circuits from one power to the other power automatically, to ensure normal power supply of load circuits.The ATSconforms to IEC60947-6-1 and GB/T14048.11
Normal conditions for operation and installation:
Environmental Temperature Condition:-5~+40°C
Installation site is not more than 2000 meters above sea level.
Pollution Level: Grade 3
Installation Category: 3
Vertical installation or horizontal installation
Technical Specification
OurRP6-63H 2P 63A 220V MCB type Dual Power Automatic transfer switch ATSalso have many advantages than most of other factories,details as following:
ATS can be installed in power control cabinet directly. Users can wire after ATS installation (refer to design and use). As per current value use suitable conductor to connect the mains side (top terminal) and load side (bottom terminal) of MCB of normal electric power and standby electric power. In-phase parallel connection at load side, and ensure the phase sequence of normal electric power and standby electric power must be accordant (Wire as per A,B,C,N sequence). For 3 poles ATS should add one conductor with section not less than 0.3mm2to connect theneuter line of power supply correctly, thus ATS can work properly. For 4 poles or 2 poles ATS, N pole of normal electric power and standby electric power should be connected to N pole of MCB respectively. In addition, when install ATS please ground reliably at grounding mark.
Auxiliary terminal is active contact signal, only used for external connection with indicator to display Off state, should be connected to the indicator directly. Cant put