Feature

●High Sensitivity: PWM control relay can be set in a wide range of scenes, control the LED light, very sensitive light control, small and light weight does not add extra weight to your RC car
●3 Seconds Delay: The PWM in the control relay switch means rudder signal, and this device can be used if you can control the rudder. If there is a solder joint, it can be set to automatically cut after 3 seconds delayed
●Normally Open and Common Terminal: PWM control relay is connected to the normal open and common terminal (1750us) (Normally close and common terminals are disconnected), and then the common terminals are connected at less than 1750us
●Adaptable to Higher Voltage: Unlike FETs, the PWM control relay switch is physically direct, so it can adapt to higher DC voltage and can be connected to AC power supply
●Automatic Disconnection: When the PWM control relay soldered two solder joints, the automatic cutting mode is turned on, and the channel value is operated at a higher level and the normal open and common conductivity will be automatically cut for 3 seconds. Or it can work. Pre-cut within 3 seconds


Description

1.Adaptable to Higher Voltage:Unlike FET, the PWM control relay switch is physically direct, so it can adapt to higher DC voltage and connect to AC power supply.
2. Normal Open and Common Terminals: PWM control relay is connected to normal open and common terminals (>1750us) (Normally close and common terminals are disconnected), and 3.3 seconds delay: PWM in the control relay switch. If you receive a rudder signal and control the rudder, you can use this device. If there is a solder joint, it can be set to automatically cut after 3 seconds delayed.
4. Automatic Disconnection: When the PWM control relay soldered two solder joints, the automatic cutting mode is turned on, and the channel value is operated at a higher level and the normal open and common conduction will be automatically cut for 3 seconds. Or it can work. Pre-cut within 3 seconds.
5. High sensitivity: PWM control relay can be set in a wide range of scenes, control the LED light, very sensitive light control, small and light weight does not add extra weight to your RC car.

Specifications:
Item Type: PWM Control Relay Switch
Material: Plastic and PCB
Type: RC Accessories
Input Voltage: 5V (Connect to Receiver)
Wire terminal: 30 V DC, Allowable current 2 A AC 125 V Allowable current 0.5 A Relay Coil power consumption approx. 1.5 A 140 mW
Main Board