A tool for hobbies of Kameshima Shoten "Soft Mold Mini Fruit 3 Types of Orange, Pine and Raisin (Ultra Small)".
A convenient silicone mold that can be used with UV-LED resin and resin clay, air-dried clay or oven clay.
You can make 3 types of fruit motif parts (slice orange, slice pineapple and raisin).
Finished size (approx.)
Orange: 10 x 2.5 / 8 x 2 / 6 x 1.5 mm
Pine: 8 x 11 x 4 / 6 x 9 x 3 / 5 x 7 x 2.5 mm
Raisin: 0.2 x 0.2 x 0.2 x 0.1 inches (5 x 7 x 4 / 4 x 5.5 x 2 / 2.5 x 3 x 1.5 mm)
Approximate amount of clay required for one motif (approximate): All parts are less than 0.0008 oz (0.2 g) each.
Since it is not a mirror finish, it will become cloudy if removed after hardening.
Apply UV resin or glossy varnish twice and coat the surface for a clean finish.
Application of abrasives depends on the UV resin used.
Squeeze air bubbles by squeezing them with a work stick.
If there is bubbles, apply resin to the groove of the mold with a hard brush, etc., and then spray the resin to prevent air bubbles.
In addition, when the resin is inserted into the mold, heat it with a hair dryer or embossing heater, and then cure it to prevent wrinkles and bubbles.
Cannot be used on silicone materials.
Materials other than natural dry clay, there are limited effectiveness associated with chemical changes.
The sample (parts) in the image is an example of the work. Not included in the product
該当なし